Inhoudsopgave
Advertenties
Certificatie en naleving
Elektronische informatie (e-label)
Wettelijk verplichte informatie is beschikbaar in de
instellingen van het scherm. Tik in het beginscherm op
Instellingen
Over
Wettelijk verplichte informatie.
Federal Communication Commission
interference statement
FCC
Suppliers Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Unique Identifier: IDQR65-A, IDQR75-A, IDQR86-A
Responsible Party – U.S. Contact Information
SMART Technologies Inc.
2401 4th Ave., 3rd Floor
Seattle, WA 98121
compliance@smarttech.com
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received,
including interference that may cause undesired
operation.
NB
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference when the equipment is operated in a
commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. Operation of this equipment in a
residential area is likely to cause harmful interference in
which case the user will be required to correct the
interference at his own expense.
Let op
Any changes or modifications not expressly approved by
the party responsible for compliance could void the
user's authority to operate this equipment.
Restriction
Operations in the 5150–5250 MHz and 5925–6425 MHz
bands are restricted to indoor usage only.
IEEE 802.11b or 802.11g operation of this product in the USA is
firmware limited to channels 1 through 11.
docs.smarttech.com/nl/kb/171958
Let op
i. the device for operation in the band 5150–5250
MHz is only for indoor use to reduce the potential
for harmful interference to co-channel mobile
satellite systems;
ii. the maximum antenna gain permitted for devices
in the bands 5250–5350 MHz and 5470–5725 MHz
shall comply with the e.i.r.p. limit; and
iii. the maximum antenna gain permitted for devices
in the band 5725–5825 MHz shall comply with the
e.i.r.p. limits specified for point-to-point and non
point-to-point operation as appropriate.
iv. Users should also be advised that high-power
radars are allocated as primary users (i.e., priority
users) of the bands 5250–5350 MHz and 5650–
5850 MHz and that these radars could cause
interference and/or damage to LE-LAN devices.
v. Operation in the 5925-7125 MHz band shall be
limited to indoor use only.
vi. Operation on oil platforms, automobiles, trains,
maritime vessels and aircraft shall be prohibited
except for on large aircraft flying above 3,048 m
(10,000 ft).
vii. Devices shall not be used for control of or
communications with unmanned aircraft systems.
Radiation exposure statement
This equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance of
20 cm between the antenna of this device and all nearby
persons. This transmitter must not be co-located or
operated in conjunction with any other antenna or
transmitter.
Innovation, Science and Economic
Development Canada statement
This device complies with RSS-247 and RSS-248 of the
Innovation, Science and Economic Development Canada
Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received,
including interference that may cause undesired
operation.
41
Advertenties
Hoofdstukken
Inhoudsopgave
