Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION
1.
Connect loudspeaker system (MINIMUM load 4 ohms) with sufficient handling capacity to the output terminals of the
amplifier.
2.
Connect output from mixer ( or any other suitable signal source) to the appropriate input sockets of the power amplifier.
3.
Connect the power cord to the mains.
4.
Turn gain controls to minimum , switch on the amplifier.
5.
Adjust the volume controls to required level. NOTE. If the audio input signal is too high, distortion will result and the
CLIP indicator will light. If the clip LED is lit permanently or flashes, the level should be reduced.
For reliable and trouble free operation, please observe the following points:
•
Ensure all input / output connections are correct and secure.
•
The handling capacity of the loudspeakers is adequate for the output of the amplifier.
•
Always site the amplifier in a well ventilated location
•
Protect unit from severe shocks
•
Do not plug in or unplug the speakers during the operation of the amplifier. This would seriously damage the
amplifier.
SPECIFICATIONS
Max Output Power @ 4 Ohm
Load Impedance minimum
Connectors
Input Sensitivity
Input Impedance
Frequency Response
THD +N
Signal to Noise Ratio.
Cross-talk
Indicators
Mains Power
Fuses
Dimension(W X D X H)
Weight
SPL300-400
2 x 150 W
Input
Output
SPL 300
4 Ohm
Cinch Buchse
Lautsprecherklemmleiste
775 mV
10 K min.
20 Hz - 20 KHz ±3 dB
Clip / Signal / Power
220~240 Vac(Euro) / 50 Hz
T1 A
482 X 290 X 88mm
3.2 kg
- 4 -
Rear Panel
1.
Inputs Channel A & B (
RCA phono sockets)
2.
Channel A & B output
3.
Mains input power & fuse
holder
SPL 400
2 x 200 W
Advertenties
Inhoudsopgave
