Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Before use / Use / Maintenance and cleaning / Service
detailed image in Fig. C. Ensure that the nail
heads are all at the top.
NOTE: Observe the maximum capacity of ap-
prox. 85 staples or approx. 75 nails when filling.
A fter filling, push the magazine slider
the magazine
as far as it will go until you
5
hear and feel it engage.
NOTE: The magazine filling level indicator
allows you to see whether there are still staples
in the magazine.
Setting the impact force
Q
NOTE: Select the lowest impact force necessary
for your stapling.
Take into account the length of the staples or nails
to be used and the strength of the materials to be
joined.
Impact force controller
Increase impact force:
T urn the impact force controller
Decrease impact force:
T urn the impact force controller
Use
Q
Switching on and off
Q
S et the ON / OFF switch
switch on the device.
S et the ON / OFF switch
switch off the device.
Stapling / nailing
Q
S witch the device on by setting the ON / OFF
switch
to position "I".
2
P ress the device with its front plate
point on the surface of the material where you
wish to staple or nail.
P ress the trigger
.
1
26 GB
All manuals and user guides at all-guides.com
Q
into
4
cause:
A staple or nail is blocking the device.
6
Solution:
Q
the mains plug out of the mains socket before you
clean or maintain the device.
3
The electric nailer / stapler is designed to be main-
anticlockwise.
tenance-free.
3
clockwise.
3
to position "I" to
2
Q
to position "0" to
2
at the
7
NOTE: The integral safety lock in the front
plate prevents unintentional firing.
Troubleshooting
O pen the magazine slider
the pretension. Release the screws on the front
plate
using the Allen key (Fig. D).
7
R emove the staple or nail.
Maintenance and cleaning
DANGER OF INJURY! Pull
A lways keep the device clean, dry and free
from oil or grease.
C lean the device immediately after you have
finished using it.
D o not allow any liquids to enter the device.
U se a cloth to clean the housing. Never use
petrol, solvents or cleaning agents that might
attack plastic.
Service
Have your device
repaired at the service centre or by
qualified specialist personnel using
original manufacturer parts only. This
will ensure that your device remains safe to use.
If the plug or lead
needs to be replaced, always have
the replacement carried out by the
manufacturer or its service centre. This
will ensure that your device remains safe to use.
. This releases
4
Advertenties
Hoofdstukken
Inhoudsopgave
