Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
RZ_prima 8_980042-00.qxp_Text_GB_prima 8 16.06.17 14:13 Seite 18
4
Technical data
Pressure sprayer: prima 8
Spray
pattern
hollowcone
Permissible positive operating pressure 3 bar / max. filling volume: 8 litres / overall filling volume:
> 13.7 litres / permissible operating temperature: + 40°C / empty weight: 2,0 kg / gross weight:
10,0 kg / reaction force on the nozzle: < 5 N / spray pipe holder / piston pressure gauge with inte-
grated safety valve / storage tank material / pump material: Polyethylene
5
Assembly >> Figure
6
Commissioning
WARNING
CAUTION
ing components may result in draining or spouting of spraying agent. Always comply with
the following safety information/safety measures:
Inspect all screw joints for tight fitting.
Prior to each use, check the device to ensure fault-free condition and leak-tightness.
To perform the leak test, fill the container with water and pressurise.
6.1 Inspect piston pressure gauge with integrated safety valve "K"
>>
Figures
CAUTION
Observe the max. filling level (see Technical specifications).
Press the piston pressure gauge with integrated safety valve "K" until the unit is depressurised.
Empty the tank.
6.2 Operate at optimum tank pressure >>
WARNING
manufacturers must be observed with regard to special hazards (R-phrases / GefStoffV [Haz-
ardous Substances Ordinance]) and safety advice (S-phrases / GefStoffV [Hazardous Sub-
stances Ordinance]), as well as dosage specifications.
NOTE
information on whether you are operating the unit at the optimum spraying pressure. The permis-
sible operating pressure of 3 bar may not be exceeded.
Bore hole
Sprayangle
Flow rate in l/min
1 mm
0-60°
0.33/0.43/0.49/0.54
1.5 bar / 2.0 bar / 2.5 bar/ 3.0 bar
1
–
Before putting into operation, observe Chapter 2 "For your safety".
Danger to health due to escaping spraying agents! A leaking device or leak-
–
7
4
Prior to filling the sprayer, the instructions given by the spraying equipment
>>
Figure
11
The piston pressure gauge with integrated safety valve "K" gives
Marking
at pressur/bar
brass
3
Figures
–
8
18
Optim. presure
Filter
1.5 - 3 bar
Serie
12
Advertenties
Hoofdstukken
Inhoudsopgave
