Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION
Operating the remote control: (right hand button if there are 2)
1. Press the button once = alarm activate/deactivate with beep signal.
2. Keep the button pressed in = alarm activate/deactivate without beep signal. (If
there is interference from incident light it is possible that with the IR remote
control will not work).
3. Press again within 5 seconds of the alarm being activated = warning sensor(s)
switched out (a beep will be heard as confirmation).
NOTE:
•
Five seconds must be waited between switching the alarm IN and switching it OUT.
•
The alarm only becomes active after 5 seconds of being switched on.
•
If the alarm is to be switched out while the siren is sounding, then it is best to keep
button pressed down on the remote control transmitter unit.
Operation of the dashboard LED:
•
Out: alarm out
•
Slow flash: alarm on.
•
Rapid flash: automatic reset of alarm after switching alarm out, ie there are 60
seconds available to get in and/or start ignition.
Audio and visual signals:
2 x flashes and sound: = alarm on
1 x flash and sound: = alarm off
4 x flashes and sound: alarm off and has been triggered
OVERVIEW OF OPERATION AND INDICATORS
Function
Dashboard
LED
Interior siren
Hazard
lights
Start
not possible
Siren/
Pager
Central
locking
K4400
module
Diagnostic function:
12
activate
deactivate
Flashing
Rapid
flash
2 x beep
1 or 4 x beep
2 x flash
1 or 4 x
flash
possible
off
locked
open
off
warning
sensor
1 x beep
1 x flash
not possible
off
short on
locked
off
on
warning
direct sensor
sensor x2
on
flash
not possible
possible
on
locked
off
on
flash
not
on
locked
off
Advertenties
Inhoudsopgave
