Advertenties
Beschikbare talen
Beschikbare talen
B
Follow the steps below to add regenerating salt:
• Remove the lower rack and unscrew the container cap.
• Place the end of the funnel into the hole and pour in approximately 1.5 kg of regenerating
salt.
• Fill the salt container with water up to the maximum limit. It is normal for a small amount
of water to spill out of the container.
• After filling the container, screw the cap back on tightly.
• The salt indicator light will turn off once the container has been filled with salt.
• Immediately after filling the salt container, a wash programme should be started (we
suggest using a short programme). If not, the filter system, pump or other important
parts of the machine could be damaged by the salt water. This is not covered by the
warranty.
PLEASE NOTE
The salt container should only be filled when the corresponding
indicator light ( ) on the control panel lights up. Depending
on how quickly the salt dissolves, the salt indicator light may
remain on even though the container is full.
CAUTION
Risk of corrosion and perforation of the tank or parts of the
appliance: If you have spilled salt into the tank during filling,
please immediately rinse the area where the salt has been
spilt or start a washing programme.
Be especially careful when starting a programme with a
delayed start.
Using the appliance
8
EN
Advertenties
