Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3.2.2. Assembly of the smoke dome and of the flue collar
The smoke dome must
be fixed to the top of
the device and attached
by means of the clamps
supplied. Assure proper
sealing by means of the
kit or paste supplied.
It is recommended to
install the smoke dome
with its exhaust back-
wards. In case of proper
draft, it may be turned
up to 90° to the left or
to the right if required
for installation. In case
of lower draft, an angle
of maximum 60° is rec-
ommended.
The flue collar can be
installed either horizon-
tally or vertically. Fix the
flue collar on the smoke
dome
with
2
bolts
M6x30, 2 nuts M6, and
4 collars Ø6xØ12. Assure proper sealing with kit or paste.
3.2.3. Installation of the ashtray (if applicable)
The optional ashtray is installed as follows:
•
Lift the plate in the middle of
the bottom brick; insert a
screwdriver into the hole to
lift the brick (if necessary, tap
the brick with a hammer to
loosen it).
•
Extrude
the
pre-cut
from the bottom heat shield.
•
Clean the sealing edge and
put the supplied rope (diam.
6 mm) in the groove; install
then the ashtray holder.
•
Tighten the 4 plate screws in
the ashtray holder and assure
proper sealing with kit or
paste.
•
You can now install the ashtray and the grid.
2300 - 2400
plate
33
KIT
03.27865.100
Advertenties
Inhoudsopgave
