Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
TECHNICAL SPECIFICATIONS
UNITO LAVA Smart Water System
Dispensing water types :
Ÿ
Ambient water, Cold / Hot tap water.
Boiling capacity:
Ÿ
Heating time:
15 minutes (from 20°C to 100°C at room temperature).
Ÿ
Min./Max. main pressure:
Ÿ
System max. safety pressure:
Ÿ
Max. hot water temperature :
Ÿ
Operation:
Ÿ
Power supply :
Ÿ
Max. power consumption:
Ÿ
-
Standby power consumption :
Ÿ
Safety features:
Maximum temperature fuse, Safety valve(including
Ÿ
pressure relief valve , a built-in one direction valve).
Dimensions:
Ÿ
Weight:
Ÿ
Flow rate:
Ÿ
Max. water hardness :
Ÿ
CARE AND MAINTENANCE
Regular maintenance of the UNITO LAVA Smart Water System
is required to prevent damage or downtime. Service should be
performed by qualified and certified personnel only.
Warning: Disconnect the power supply from the UNITO LAVA
Smart Water System before maintaining the unit。
Keep the UNITO LAVA Smart Water System in a dry, clean
Ÿ
space. Minimize exposure to dust. Power button or other
controls should never be wet.
If the unit becomes wet, immediately shut it down. Wait for the
Ÿ
unit to completely dry before turning it on again.
Clean exterior surfaces of the unit with a soft, lint-free cloth.
Ÿ
Never use alcohol, paint thinner, benzene or other solvents to
clean this unit. Never use an abrasive material such as a
brush or scouring pad to clean surfaces.
Always test your cleaning solution on an inconspicuous area
Ÿ
before applying to the entire surface.
Wipe surfaces clean after applying cleaner.
Ÿ
Never expose the unit to vibration.
Ÿ
Make sure that all cabin ventilation outlets are always free
Ÿ
and clear.
In the event of mechanical/power failure or damage, do not
Ÿ
attempt to repair the system unit or wires. Call a certified
technician.
If the UNITO LAVA Smart Water System requires service,
Ÿ
please consult a certified dealer. Unauthorized service may
void the warranty.
Close/open the system valve and safety valve every 6
Ÿ
months.
It is recommended to sanitize the unit every 6 months.
Ÿ
37
Boiling water, Mix hot / cold,
4.4 Litres or 8 Litres.
2 / 5 bar (200 / 500 kPa).
6 bar (600 kPa).
Operation via Electronic control knob, handle.
220 ~ 240 VAC, 50 ~ 60 HZ.
4.4L 1550 W.
Boiler: 255 x 401 x 486.6 mm.
Total weight: 12 kg.
2.0 L / min(Water pressure is 3 bar ).
TROUBLESHOOTING
Read and follow the assembly instructions. If the UNITO LAVA
Smart Water System is not functioning, please check
troubleshooting table. If the water system is still not working
properly, disconnect power supply and contact authorized
UNITO customer service center for assistance. When calling for
assistance, please provide your product model and serial
number.
Symptom
No water
flowing, the
100°C.
water is
flowing too
slow
8L 2550 W.
The water is
2.0 W.
sputtering
or is
irregular
10° dH.
No boiling
water
ERROR LIST
Description
Water leakage
detected
Boiler
malfunction
Boiler not
activated
Boiler
malfunction
Possible Cause
Solution
- Main water supply
- Turn on the main water
valve.
supply valve.
- Check whether hoses are
- Hoses are twisted.
twisted.
- Check the water pressure.
It should be above 2.0 bar.
Check a different tap. If the
- There is no or too little
pressure is also low there,
water pressure.
check the mains water tap
and contact your water
supplier.
- Clean or replace the
- Areator.
aerator.
- The boiler is turned off
or not connected to
- Connect to power supply.
power supply wall socket.
- Re-install the filter to the
- Filter not installed well.
correct position.
- Main water supply
- Turn on the Safety valve or
valve is turned off.
main water supply valve.
- Faulty Safety valve(cut-
- Contact UNITO customer
off).
service.
- The boiler is not
- Please follow page 20 (or
activation.
Page 23 Orbit faucet).
Panel Display
Follow up action
(heater)
Turn off water supply, remove
system power cable and call
UNITO service
Requires service
Please follow page 20 (or Page 23
Orbit faucet)
Cutoff protection - active
Deactivate the protection or call
repair service
Advertenties
Inhoudsopgave
