Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
7
Troubleshooting
Drying process takes too much time.
•
Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
•
Filter drawer is clogged.
•
Ventilation grids on the front side of the machine are blocked.
that block ventilation in front of the ventilation grids.
•
Ventilation is not sufficient since the room where the machine is installed is very small. >>> Open the
door and window of the room to avoid the room temperature increase too much.
Lime deposit has built up on the dampness sensor. >>> Clean the dampness sensor.
•
•
Excessive laundry is loaded. >>> Do not load the dryer in excess.
•
Laundry is not spun sufficiently. >>> Spin your laundry at a higher speed in your washing
machine.
Laundry comes out wet at the end of drying.
C
After drying, the hot clothes feel damper than their actual dampness level.
•
It is likely that the selected programme did not suit the laundry type.>>>Checking the care labels on
clothes, select appropriate programme for the laundry type or use timer programmes in
addition.
•
Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the filter drawer.
•
•
Excessive laundry is loaded. >>> Do not load the dryer in excess.
•
Laundry is not spun sufficiently. >>> Spin your laundry at a higher speed in your washing
machine.
Dryer does not switch on or the programme does not start. Dryer does not start when it is set.
•
It is not plugged in. >>> Make sure that the machine is plugged in.
The loading door is ajar. >>> Make sure that the loading door is closed securely.
•
Programme is not selected or the Start / Pause / Cancel button is not pressed. >>> Make sure that the
•
programme is selected and the machine is not in Pause mode.
Childproof Lock is activated. >>> Deactivate the Childproof Lock.
•
Programme is interrupted without any cause.
•
Loading door is ajar. >>> Make sure that the loading door is closed securely.
•
There was a power failure. >>> Press Start / Pause / Cancel button to start the programme.
Water tank is full. >>> Drain the water tank.
•
Laundry has shrunk, become felted or deteriorated.
A programme suitable for the laundry type is not used. >>> Check the garment tag and select a
•
programme suitable for the fabric type.
Drum lighting does not turn on. (On models with lamp)
Dryer is not switched on with the On / Off button. >>> Make sure that the dryer is switched on.
•
Lamp is defective. >>> Call Authorized Service Agent to have the lamp replaced.
•
End/Anti-creasing symbol is on.
•
Anti-creasing programme is activated in order to prevent laundry that has remained in the machine from
creasing. >>> Turn off the dryer and take out the laundry.
58 / 60 EN
Clean the sponge and the filter cloth in the filter drawer.
>>>
Remove the objects (if any)
>>>
Dryer / User Manual
Advertenties
Inhoudsopgave
