Advertenties
Beschikbare talen
Beschikbare talen
B
Step 3. Tension adjustment of the door spring
1. The door springs are set at the factory to the proper tension for the outer door. If aesthetic
panel are installed, you will have to adjust the door spring tension. Rotate the adjusting
screw to drive the adjustor to strain or relax the steel cable.
2. Door spring tension is correct when the door remains horizontal in the fully opened
position, yet rises to a close with the slight lift of a finger.
Step 4. Dishwasher installation steps
NOTE
Please refer to the specific installation steps in the
installation drawings.
1. Affix the condensation strip under the work surface of cabinet. Please ensure the
condensation strip is flush with edge of work surface. (Step 2)
2. Connect the inlet hose to the cold water supply.
3. Connect the drain hose.
4. Connect the power cord.
5. Place the dishwasher into the cabinet.
6. Level the dishwasher. The rear foot can be adjusted from the front of the dishwasher by
turning the Philips screw in the middle of the base of dishwasher use a Philips screw driver.
To adjust the front feet, use a flat screw driver and turn the front feet until the dishwasher is
level. (Step 5 to Step 6)
Using the appliance
16
EN
Advertenties
