ACCESSORIES REPLACEMENT
Before replacing any accessory, according to the operation to be carried out,verify that the plug has
been disconnected from the power source.
1. Block the shaft rotation by pushing the block button (1 in picture 1) and, at the same time, rotate
counter-clockwise the closing screw (2 in picture 1) which blocks the accessory in order to take it out
completely. Remove both the accessory and the mandrel by using the regulation key (2 in picture 1).
2. Among the mandrels available inside the kit (for example 3 in picture 2), get the most suitable one for
the accessory to be used (for example 6 in picture 2) . Insert the mandrel in the Tool shaft (4 in picture
2) the insert the accessory first in the closing screw (5 in picture 2) and finally in the mandrel.
3. Block the shaft rotation by pushing the block button (1 in picture 1) and at the same time rotate
clockwise the closing screw (5 in picture 2) in order to block the accessory. Use theregulation key for
this purpose (2 in picture 1).
Before using the Tool verify that the accessory is correctly locked up by the closing screw.
Picture1
Picture 2
Picture 3