Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
RESETTING THE SATURATION INDICATOR
The appliance gives an alarm on the display for certain cleaning and replacing intervals.
1. Make sure that the appliance is switched off.
2. Touch and hold the child lock button for 3 seconds to enter the lock modus.
3. Touch and hold the cooker hood button for 3 seconds to reset the saturation indicator. The operation indicator
shows "CL".
8
Troubleshooting
GENERAL TROUBLESHOOTING PROCEDURE
1. Try to find a solution for the problem with the help of the troubleshooting table and the breakdown codes.
2. If you cannot find a solution for the problem or the breakdown code keeps re-occuring, contact Inventum-
servicedienst
TROUBLESHOOTING TABLE
Problem
The induction hob does not start.
The operation indicator on the
control panel of the induction hob
shows U.
A cooking zone switches off
automatically. The operation
indicator on the control panel of the
induction hob shows H.
The operation indicator on the
control panel of the induction hob
shows L.
The display on the control panel of
the cooker hood shows F.
38
•
English
Possible cause
There is no mains supply.
The child lock is activated.
The touch buttons are covered with
water or dirt.
There is no pan on the cooking zone. Put a pan on the cooking zone.
The pan is too small (< 14 cm) or not
suitable for an induction appliance.
The cooking-time limit is reached.
Automatic cooking-
Refer to section
time limiter
.
The touch buttons are covered.
There is an empty pan on a cooking
zone and the bottom is overheated.
The child lock is activated.
The carbon filters are worn.
Possible solution
•
Do a check if the mains plug is
correctly connected to the mains
socket.
•
Make sure that the mains supply
is on.
Deactivate the child lock. Refer to
Locking and unlocking the
section
appliance
.
Clean the appliance. Refer to section
Daily cleaning
.
Use a pan that is suitable for an
induction appliance. Refer to section
Requirements for pans
.
1. Start the appliance. Refer to
section
Start cooking
2. Select a cooking zone. Refer to
Start cooking
section
Remove the blockage.
Remove the pan from the cooking
zone.
Deactivate the child lock. Refer to
Locking and unlocking the
section
appliance
.
1. Replace the carbon filters. Refer
to the instructions supplied with
the carbon filters.
2. Reset the alarm. Refer to
Resetting the saturation
section
indicator
.
.
.
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
