Bestway 58515 Handleiding pagina 7
Verberg thumbnails
Zie ook voor 58515:
- Gebruiksaanwijzingen (10 pagina's) ,
- Gebruiksaanwijzingen (172 pagina's) ,
- Gebruikershandleiding (37 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ASSEMBLY
1. Carefully remove all components from the package and check to ensure nothing
is damaged. If equipment is damaged, immediately notify the retailer from where
the equipment was purchased.
2. The sand filter should be placed on solid, level ground, preferably a concrete
slab. Position the sand filter so the Ports and Control Valve are accessible for
operation, servicing and winterizing.
3. EN60335-2-41 TEST standard requires the sand filter to be vertically fixed on
ground or a certain pedestal made of wood or concrete before use to prevent
the sand filter from accideutally falling. Fully assembled sand filter will exceed
18 kg. The mounting holes should be 8 mm in diameter and spaced 285 mm
apart. Use two bolts and nuts with a maximum of 8 mm in diameter to fasten
the sand filter to the pedestal.
IMPORTANT: Do not place chlorine in the strainer to avoid damaging the sand filter.
LOAD POOL-GRADE FILTER SAND/POLYSPHERE™ POOL FILTRATION BALLS.
NOTE: Use only special pool-grade filter sand, free of all limestone or clay: #20 Silica sand 0.45-0.85 mm, approximately
one 8.5 kg bag should suffice. If you do not use the recommended size filter sand, filtering performance will be reduced
and the sand filter may damaged, thereby voiding warranty.
NOTE: To avoid damaging the Skimmer when adding sand, pour some water into the Bottom Tank to submerse the
Skimmer on the Collector Hub.
NOTE: Sand/Polysphere™ Pool Filtration Balls not included.
NOTE: Use 28 g (0.06 lbs) Polysphere™ Pool Filtration Balls to replace 1 kg (2.20 lbs) sand.
1
2
5
c
c
CONNECT TO THE POOL
V1
(You will need a screwdriver.)
3
6
MAX
MIN
MAX
MIN
7
A
B
A
A
A
B
7
285mm
4
MAX
MAX
MIN
MIN
c
A
c
B
A
A
B
B
Φ8mm
A
Advertenties
Inhoudsopgave
