Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Working with the tripod
Setup and alignment
1. Pull all the three legs
which is connecting all the three cross hinges will be moved to the
end of the middle column.
2. Release the blocking levers
your desired height.
3. Then, fold-back all those blocking levers
4. Check the straight positioning by using the bubble level
tripod is straight, the air bubble will be positioned in the centre of
the circle. If necessary, readjust the length of the legs
5. If additional height is necessary, loosen the locking screw
extend the centre column to desired height. Once reached the
desired height, tighten the locking screw
6. For a horizontal alignment of the tripod flat head
long handle
or down as desired. If the air bubble of the spirit level
exactly in the middle of the circle, the tripod flat head is aligned
horizontally. Then, tighten the long handle
7. If necessary, loosen the locking screw
head
up to 360 degree horizontally to get desired side. Once
18
reached the desired side, tighten the locking screw
8. If necessary, loosen the locking screw
tripod flat head
Once reached the desired angle, tighten the locking screw
Securing the Cross Line Laser
Align
-thread
screw
of the quick shoe and make sure to tighten the screw well by
8
screwing the metal bracket
the bottom side of the quick shoe
Removing quick shoe from tripod:
User can just remove the cross line laser together with quick shoe
from tripod by following below steps:
1. Pull the lever
2. Remove the quick shoe
3. If want to put back the cross line laser on the tripod again, pull the
lever
on the tripod flat head
11a
back firmly on the tripod flat head
to bring back to original position and to firmly hold the quick shoe
(see fig. A).
19
14 GB/IE/NI
of the tripod apart. The plastic ring
17
16
by turning anti-clockwise and move the handle up
12
up to 90 degree vertically to get desired angle.
18
of cross line laser with the
6
clockwise. The metal bracket
9
on the tripod flat head
11a
.
19
and extend the legs until you get
.
16
.
14
by turning it clockwise.
12
to rotate the tripod flat
13
to adjust the angle of the
10
-quick-release fixing
.
19
along the side.
18
and place the quick shoe
18
. Then, release the lever
18
,
15
. If the
11
.
17
and
14
, loosen the
18
is located
11
.
13
.
10
is on
9
19
19
11a
Advertenties
Hoofdstukken
Inhoudsopgave
