Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
HOT AIR FRYING
Connect the mains plug into an earthed wall socket
1.
Carefully pull the pot out of the Hot-air fryer.
2.
Put the ingredients in the pot.
3.
4.
Slide the pot back into the Hot-air fryer
Noting to carefully aligning with the guides in the body of the fryer.
Caution: Do not touch the pot during and some time after use, as it gets very hot. Only hold
the pot by the handle.
Determine the required preparation time for the ingredient (see section Settings' in this chapter).
5.
Some ingredients require shaking halfway through the preparation time (see section "Settings"
6.
in this chapter). To shake the ingredients, pull the pot out of the appliance by the handle and
shake it. Then slide the pot back into the air fryer
When you hear the timer buzzer, the set preparation time has elapsed. Pull the pot out of the
7.
appliance
Note: You can also switch off the appliance manually. To do this, set the time to 1.
Tip: You can adjust temperature or time according to your taste during use. Your settings will be
kept for about 10 mins after you pull the pot out of the body.
Check if the ingredients are ready
8.
If the ingredients are not ready yet, simply slide the pot back into the appliance and set the timer
to a few extra minutes.
To remove ingredients (e.g. fries), pull the pot out of the Hot-air fryer and place it on trial
9.
framework, lift the fried plate out of the pan.
Do not turn the fried plate upside down with the pot still attached to it, as any excess oil that has
collected on the bottom of the pot will leak onto the ingredients. the pot and the ingredients are
hot. Depending on the type of the ingredients in the air fryer, steam may escape from the pot.
10. Empty the pot into a bowl or onto a plate.
11. When a batch of ingredients is ready, the Hot-air fryer is instantly ready for preparing another
batch.
CONTROL PANEL INSTRUCTIONS
OPERATION INSTRUCTIONS:
After the machine is powered on, all the indicators and digital tubes will be on for 1 second and
1.
then off. At the same time, the buzzer will ring and the power lamp AA will be on.
Press the AA key for 0.5 seconds to start the machine. After the machine is started, 8 lights on
2.
the two screens are off, and the other lights on the two screens are «--»
At this point, consumers choose pot I or pot 2 according to their needs. Choose AA , than AA
3.
and AA light blink, The corresponding menu indicator blinks. The display of pot 1 lights up
and displays the default menu of 180°C/15min or 360°F/15min. The temperature and time are
displayed alternately. The left and right indicators of the display are displayed Corresponding
Advertenties
Inhoudsopgave
