Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
3 . Check whether the product and all
parts are in good condition, if any
damage or defect is detected, do
not use the product, but follow the
procedure described in chapter
"Warranty" .
˜ Inserting/exchanging the
battery
1 . Unscrew the battery compartment
lid
2 ]
[
2 . Remove the foil from the 9 V block
battery
3 . Insert the 9 V block battery
the +/– poles facing downwards
into the battery compartment . Fit the
+/– poles in the moulds of the battery
compartment (Fig . B) .
4 . Screw the battery compartment lid
onto the product .
˜ Operation
˜ Switching the product on
INFO: Keep the product away from
metallic objects while switching it on .
This is necessary so that the product
can calibrate itself .
1 . Press
The product calibrates itself for
–
about 2 seconds . During this time,
the LED bar
off again . The product emits a single
sound-and-vibration alert .
The flashlight
–
2 . The product is ready for use .
1 LED
–
˜ Switching the product off
Press and hold
o
The product emits a sound-and-
–
vibration alert twice .
˜ Detecting metallic objects
1 . Switch the product on and wait until
the product is ready for use (see
"Switching the product on") .
2 . Hold the product by the handle
3 . Point the detection rod
direction where you expect to find
metallic objects . The closer the
detection rod is to metallic objects,
the higher the frequency of LED and
sound-and-vibration alerts:
.
.
3 ]
[
.
5 ]
[
6 ]
[
7 ]
[
flashes every 3 seconds .
6 ]
[
[
3 ]
goes on and then
goes on .
for 2 seconds .
5 ]
[
in a
8 ]
[
GB/IE/NI
with
2 ]
[
.
4 ]
[
11
Advertenties
Hoofdstukken
Inhoudsopgave
