Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Getting started
Follow the steps below to connect this system quickly and easily. Tip: If you encounter any
problems during installation please visit www.elro.eu. There you will find installation videos,
answers to frequently asked questions, and the latest version of this manual among other things.
Necessary materials
For the installation you need:
•
A small Philips screwdriver
•
A drill and drill bits
•
Marking-out materials
•
A 5/8" PVC pipe
•
Measuring tape
•
A level
Step 1: outdoor unit
Start the installation by mounting the outdoor unit. Place the outdoor unit on a wall or on a frame,
preferably at 1.35 - 1.7 meters high (2). Caution: make sure the sun does not shine directly into the
lens.
Remove the mounting plate from the outdoor unit
1.
Take the mounting plate and mark the drill holes where the screws will be inserted. Then drill
2.
two holes.
Mark the location of the hole where the wires will be inserted and drill a hole with a diameter
3.
of 16 mm from the outside in. Drill approximately 10 degrees upwards diagonally.
We recommend to insert a 5/8" PVC pipe in the drill hole. This tube is available in most home
4.
depots. Caution: If you need to drill through wood, use a speed drill with a diameter
comparable to that of the bell push wires.
Mount the mounting plate using the screws to the wall/frame.
5.
Push the cables of the camera into the PVC pipe from the outside in.
6.
The plugs with red, yellow, and blue wires are used for connecting an electric door
o
release.
The plugs with red, yellow, blue and white wires are used for connecting to the
o
monitors.
- 8 -
Advertenties
Hoofdstukken
Inhoudsopgave
