Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
17
"Water Filter"
In general, you should change the
water filter every 6 months to ensure
the highest possible water quality.
The state of the water filter is calculated
by the main control board and
transmitted to the display panel. The
first time the power is switched on and
the water enters the filter, the filter state
is calculated at 99%. When the water
filter state drops to 15%, the icon "
lit. When the filter state reaches 10%,
the icon "
" will blink, reminding you to
replace the water filter. You can
purchase the new filter from the retailer
where you purchased your refrigerator.
After you change a new water filter,
ensure to touch and hold the "Eco"
button for 3 seconds to reset the water
filter state. The water filter state will be
re-calculated to 99%.
Wi-Fi Function
This appliance may be controlled
remotely with a smart phone or a tablet
computer. If the appliance is not
connected to the home network, it will
function like a regular appliance.
What do you need to connect the
appliance?
Signal from the local wireless network
(Wi-Fi) should be sufficiently strong in
the spot where the appliance is
installed.
Home network router has to be
connected to the internet, and the Wi-Fi
function on the appliance should be
activated.
The smart phone/tablet computer has
to be connected to the internet.
Operating system on your smart
phone/tablet computer should be
compatible with the ConnectLife app.
APPLIANCE Wi-Fi STATE
" is
There are three WiFi states as shown
below, you can activate the display
board according to the relevant steps.
CONNECT APPLIANCE TO Wi-Fi
After activating the Wi-Fi function,
connect your device to your home
router in order to connect your
appliance with the ConnectLife mobile
app.
Step 1: Set the appliance to normal
operation. Touch the Wi-Fi icon for
approximately 3 seconds. You entered
network connection menu when '--'
appears in the display.
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
