Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
C
Useful information
NOTE
•
Do not use abrasive or caustic agents to clean plastic parts.
•
Clean the detergent dispenser every 3 months to ensure the normal operation
of the appliance.
Cleaning the Drain Pump Filter
WARNING!
•
Be careful of the hot water!
•
Allow detergent solution to cool down.
•
Unplug the machine to avoid electrical shock before washing.
•
Drain pump filter can filter the yarns and small foreign matters from the
washing.
•
Clean the filter periodically to ensure the normal operation of washing machine.
1
ΠOpen the lower cover cap
Open the filter by turning to the counter clockwise
Ž Remove extraneous matter
Close the lower cover cap
CAUTION!
•
Make sure that valve cap and emergency drain hose are reinstalled properly,
cap plates should be inserted aligning to hole plates otherwise water may leak.
•
Some machines don't have emergency drain hose, so step 2 and step 3 can
be skipped. Rotate lower cover cap directly to make water run into basin.
•
When the appliance is in use and depending on the programme selected there
can be hot water in the pump. Never remove the pump cover during a wash
cycle, always wait until the appliance has finished the cycle, and is empty.
When replacing the cover, ensure it is securely re-tightened.
2
3
26
EN
C
Useful information
Trouble Shooting
Whenever there is a problem with the appliance, check if you can solve it following the
tables below. If the problem persists, please contact the customer service.
Description
Appliance does not start
Door can´t be opened
Water leakage
Detergent residues in
the detergent dispenser
Indicator or display does
not work
4
Abnormal noise
Error Codes
Description
Possible cause
Solution
Door is not closed properly.
Close the door properly and restart.
Clothes are stuck.
Check the laundry.
Safety protection is activated.
Disconnect the power and restart.
Connections are not tight
Check and fasten the water inlet pipe.
enough.
Check and clean the outlet hose.
Detergent is damp and/or
Clean and wipe the detergent
clotted.
dispenser dry.
PC board or harness have
Switch off the power and check if the
connection problems.
mains plug is connected properly.
Check if the fixing bolts have been
Fixing bolts still in place.
removed Make sure the appliance is
Floor is not solid or level.
installed on a solid and level floor.
Possible cause
Solution
Door is not closed properly
Close the door properly and restart.
Check if the water pressure is high
Water injecting problem during
enough.
wash cycle.
Straighten the water pipe.
Clean the inlet valve filter.
Overtime water draining
Check the drain hose for blockage.
Water overflow
Restart the appliance.
Restart the appliance. If problem
Others
persists, please contact the customer
service.
27
EN
Advertenties
Hoofdstukken
Inhoudsopgave
