Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
en Installation instructions
Place the angle bracket for the flue duct on the
9.
centre line so that it is flush with the ceiling.
Measure and mark the drill holes for the fastening
screws.
Drill the holes.
10.
Insert the wall plugs flush with the wall.
11.
Screw on the angle bracket for the flue duct.
12.
Preparing the appliance
When starting up in air extraction, install the back-
▶
flow flap, if required.
Installing the appliance
WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
edges.
Wear protective gloves.
▶
ATTENTION!
If the glass flap is opened too far and the hinges over-
stretch, the appliance may be damaged.
Do not push the glass flap upwards beyond the end
▶
stop.
Do not overstretch the hinges.
▶
28
Hook on the appliance.
1.
Open the glass flap.
2.
Align the appliance horizontally using screws and
3.
screw it in tightly.
Attach and screw in the two additional safety
4.
screws.
Insert the grease filter.
5.
To avoid causing damage, do not bend the grease
filters.
Close the glass flap.
6.
Piping
Circulating-air mode
¡ If you are operating the appliance in circulating-air
mode, please observe the information about the cir-
culating air special accessory.
¡ We recommend piping with an exhaust air pipe dia-
meter of 150 mm.
¡ If the diameter of the air extraction ducting is less
than 150 mm, you need a separately available re-
duction fitting.
Note: If you are using an aluminium pipe, smooth the
connection area beforehand.
Establishing the exhaust air connection (exhaust
pipe, 150 mm diameter)
Secure the exhaust pipe to the air pipe connector.
1.
Establish the connection to the exhaust air opening.
2.
Seal the joints.
3.
Fitting the flue duct
WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
edges.
Wear protective gloves.
▶
Advertenties
Hoofdstukken
Inhoudsopgave
