Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
MARMITEK GV20 PC to TV SENDER
OWNER'S MANUAL
READ THIS FIRST!
Caution: to reduce risk of electric shock, do not disassemble any part of the videosender
system. No user-serviceable parts are inside. If you spill liquid on it, disconnect the unit from
the AC outlet to prevent possible fire or shock hazard and consult authorized service
personnel.
Use only the supplied powersupplies. Defective parts must be replaced by original spareparts
only.
Powerline operated equipment or accessories connected to the unit should bear the CE
certification mark and should not be modified in any way that might defeat the safety
features.
Warning: to prevent electric shock hazard, do not expose any part of the video Sender to
rain or moisture. Do not use near a bath tub, swimmingpool, etc. Disconnect the unit during
thunderstorms from mains and other connected equipment to avoid damage.
No guarantee or liability will be accepted for any damage caused due to incorrect use of the
equipment supplied, other than indicated in this owner's manual.
1. SETTING UP THE MARMITEK GV20 TRANSMITTER
1. Connect one set of Audio/Video cables to the VIDEO [C] and AUDIO [D] jacks of your
Marmitek GV20 Transmitter. Take care to match the colors of the plugs on the cable
with the jacks on the GV20 Transmitter.
2. Connect the other end of the cable to the Audio/Video OUT jacks of the video source you
want to transmit the signal from (e.g. your VCR, DVD, Satellite or TV). If your video source
is equipped with a SCART connector use the SCART Adapter labelled TRANSMITTER. If the
jacks are colored differently, connect the yellow plug on the jack VIDEO, the red plug on
the jack AUDIO RIGHT and the white plug to the jack AUDIO LEFT.
3. Switch the Power slide switch on the side into the "OFF" position
4. Plug the supplied mains adaptor, labelled Sender/Transmitter 12V, 200mA, into a 230Volt
50Hz wall outlet and connect the jack to the 12V jack at the rear side of the transmitter.
Only use the supplied mains adaptor!
5. Switch the Power switch to the ON position.
6. Set the Channel-switch [A] on A.
7. Position the transmitter in a convenient location and orient the antenna [K]
PC TO TV SENDER
3
Advertenties
Inhoudsopgave
