Bestway 58497 Gebruiksaanwijzingen pagina 7
Hmax 1.5 m zandfilter
Verberg thumbnails
Zie ook voor 58497:
- Gebruiksaanwijzing (12 pagina's) ,
- Gebruikershandleiding (173 pagina's) ,
- Gebruikershandleiding (41 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
ASSEMBLY
1. Carefully remove all components from the package and check to ensure nothing is
damaged. If equipment is damaged, immediately notify the retailer from where the
equipment was purchased.
2. The sand filter should be placed on solid, level ground, preferably a concrete slab.
Position the sand filter so the Ports and Control Valve are accessible for operation,
servicing and winterizing.
3. EN60335-2-41 TEST standard requires the sand filter to be vertically fixed on ground
or a certain pedestal made of wood or concrete before use to prevent the sand filter
from accidentally falling. Fully assembled sand filter will exceed 18 kg. The mounting
holes should be 8 mm in diameter and spaced 86 mm apart. Use two bolts and nuts
with a maximum of 8 mm in diameter to fasten the sand filter to the pedestal.
IMPORTANT: Do not place chlorine in the strainer to avoid damaging the sand filter.
LOAD POOL-GRADE FILTER SAND/POLYSPHERE™ POOL FILTRATION BALLS.
NOTE: Use only special pool-grade filter sand, free of all limestone or clay: #20 Silica sand 0.45-0.85 mm, approximately one 36 kg bag
should suffice. If you do not use the recommended size filter sand, filtering performance will be reduced and the sand filter may damaged,
thereby voiding warranty.
IMPORTANT: We suggest using #20 silica sand with your pool sand filter. It is specially graded to trap particles in the 20 - 100 micron range.
Some small debris can pass throw the sand and back into the pool. This is normal, especially if the debris is fine or silt.
To limit this, it is better to follow the maintenance instructions, and backwash and rinse when necessary.
We also suggest contacting your pool dealer for the chemical product specifically made to clean the sand. The correct maintenance of
the sand will optimize the cleaning efficiency and avoid accumulation of oils or scale.
When you are vacuuming the bottom of the pool that has a large amount of debris, we suggest to backwash the sand when you finish
cleaning half of the pool.
Remember to backwash and rinse the sand after vacuuming the bottom of the pool each time.
NOTE: To avoid damaging the Skimmer when adding sand, pour some water into the Bottom Tank to submerse the Skimmer on the
Collector Hub.
NOTE: Sand/Polysphere™ Pool Filtration Balls not included.
NOTE: Use 28 g (0.06 lbs) Polysphere™ Pool Filtration Balls to replace 1 kg (2.20 lbs) sand.
MAX
MIN
MAX
MIN
(You will need a screwdriver.)
7
Φ8
c
c
c
c
c
c
Advertenties
Inhoudsopgave
