Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Deutsch
Displaying of measured temperature by internal sensor
If "Err" is displayed, internal sensor is damaged.
Displaying of measured temperature by external sensor:
FLOOR temperature / AMBIENT temperature
If "Err" is displayed, external/ambient sensor isn't connected or
damaged.
Lower limit of floor temperature (FL.L)
This value is displayed and set only if parameter 21 is FLL.
This value of "low limit" will be used in heating and cooling config-
urations. Press
to increase the value
Default value: "no":
not activated
Other values: 5°C to "FL.H" (or 40°C)
High limitation of floor temperature (FL.H)
This value is displayed and set when parameter 21 is set on FL.L.
This value of "high limit" will be used in heating and cooling con-
figurations. Press
to decrease the value.
Default value: "no":
not activated
Other values: "FL.Lo" (or 5°C) to 40°C
Regulation type
- HYs:
regulation of hysteresis
- bP:
regulation of proportional type
Default value: bP
Hysteresis value
This menu is displayed only if parameter "Typ" (#26) is equal to
"HYs".
Use minus
and plus
The setting is validated with validation key
Default value: 0.3°C
|
|
Français
Nederlands
Other value: HYs
keys to set hysteresis value.
Value range: 0.2°C to 3°C
|
English
.
17
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
