Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Recommendation: Pump the product up and
leave it alone for one day. Let a new product air
outside in fresh air for a couple of days.
Recommendation: Place the mini-pool on a
level surface at least 2 m from any structure or
obstruction such as a fence, garage, house, over-
hanging branches, laundry lines or electrical wires.
Pumping up the product
CAUTION! Inflatable plastic products react sensi-
tively to the cold and hot. That is why you should
never use the product when the ambient temperature
falls to below 15 °C and rises above 40 °C.
Otherwise damage to the product may result.
Note: Basically, only an adult should be responsible
for pumping the pool up. Make sure that you do
not pump too much air into the product. On no ac-
count should you use a compressor. Stop the process
when resistance increases during pumping and the
seams start to stretch. Otherwise the material might
tear. Only use manual pumps and/or pumps specifi-
cally designed for use with inflatable plastic products.
Roll the product out first and then check for holes,
tears and other damage (see Fig. A).
Note: Use a pump with conical adapter with
a diameter of approx. 17.8 mm for the valve
opening
.
2
Take the end cap
1
order to open it.
Pump the product up.
IMPORTANT! Keep in mind that air tempera-
ture and weather conditions can affect the air
pressure inside inflatable products. In cold weather
the product behaves as if it has less air pressure
in it because the air inside contracts. Under these
conditions you may have to add air. In hot weather
the air inside expands. Under these conditions
you may have to remove air in order to avoid
overfilling.
Place the end cap
order to close it.
8
GB/IE/NI
off the stopper
in
3
onto the stopper
1
3
Deflating the product
Pull the stopper
order to open it.
Allow the air to escape completely.
Slowly fold the product together (see Fig. A).
Note: Make sure that the product is completely dry
before folding it together.
Cleaning and Maintenance
On no account should you use corrosive or
scouring detergents.
Use a slightly damp, lint-free cloth to clean the
product.
Change the water of paddling pools frequently
(particularly in hot weather) or when noticeably
contaminated.
Repairing the product
Note: Minor damage can be repaired by the owner
using the supplied repair kit. Have any major damage
carried out at a specialist repair shop.
First let all the air escape from of the product.
Cut the patch
Note: Ensure that the patch
the hole and overlaps the edges of the hole.
Round off the sides of the patch
off the protective foil.
Place the patch
down firmly. If necessary, stand a heavy object
on the patch
Wait for 24 hours before you pump up the
product again.
Storage instruction
in
Make sure that the product is completely dry
both inside and out when wishing to store it for
any length of time. Otherwise mildew and mould
may form.
off the valve opening
3
to suit the size of the hole.
4
is larger than
4
and pull
4
on the hole and press it
4
.
4
in
2
Advertenties
Hoofdstukken
Inhoudsopgave
