Advertenties
Beschikbare talen
Beschikbare talen
EN
Manual
Install the lights
1
Align the pins
Align the 2 pins of the split
ground stakes inside each other
(slide them together as an cross).
Attach to housing
3
Click the cross fitted ground pin
downwards into the main housing
and make sure it fits tight and
straight into the holes on the back
of the solar main housing light
Make sure it fits firmly
2
Make sure it will fit firmly together
properly as shown
Place in ground
4
Flip it over and install and push
downwards in the desired
location and to the best sunny
location possible while installing
on a soft ground location.
Note: If there's sunlight or other lights on the solar panel, the lamp
will not be ON even if the ON/OFF switch has been turned ON. During
testing, other object (paper board, hand or arm) should be used to cover
the complete solar panel, then the lamp will be ON after turning on the
ON/OFF switch. Select a location that is not located close to other light
sources, such as for example street lighting, because this enables the
lamp to be switched off automatically when set in ON setting.
Battery warning note
New batteries must be recharged and discharged 3 ~ 5 times before their
full function use time is released. The rechargeable battery is built into the
device and can be replaced when needed. Do not throw the battery into the
fire, otherwise it may explode. Batteries may also explode if being damaged,
please handle and disposal it according to local conditions and regulations.
After 3 months long storage, need to completely discharged and recharge
for at least 80%. The battery used in this device may present a risk of fire or
chemical burn if mistreated. Do not disassemble, short contacts, heat above
60°C (140°F), or incinerate. Keep away from children. Do not disassemble
and do not dispose of in fire.
- Ensure that the device do not come into contact with heat sources, hot
objects or naked flames.
- Do not attempt to charge the device when the battery is damaged.
- Leaks from battery cells can occur under extreme conditions. If the liquid
gets on the skin, wash it immediately with soap and water. If the liquid gets
into the eyes, flush them directly with clean water for at least 15 minutes
and seek medical attention.
Operation and button use
The solar lamp can be turned on or off by the ON/OFF button:
1. Light on
Slide the ON/OFF button to ON to activate the lamp. The lamp will turn ON
automatically at sunset/night and will go OFF during sunrise/day (or when
the battery is empty) and is done automatically by the internal light sensor
inside the solar panel.
2. Light off
If you slide the ON/OFF button to OFF again, the lamp is turned OFF
completely. The solar cells will charge the battery without activating the
lamp. Leave the lamp in this position for at least 2 or 3 sunny days so the
FlinQ Solar Groundspot Fly 8-pack
Advertenties
