Advertenties
Beschikbare talen
Beschikbare talen
EN
Manual
- he product should be charged as soon as it is working to a low battery level; it is forbidden
to leave the product for a long period of time when the battery is low, which may cause the
lithium battery to over discharge and fail to charge normal!
- The fan generates heat while charging. Always charge in a well-ventilated room and open-air
area. Do not charge under pillows, blankets, clothes or on flammable surfaces.
- Keep the fan away from heat sources, direct sunlight, flammable gas, moisture, water or other
liquids.
- Do not disassemble or open. Do not microwave, burn or paint the fan or place foreign objects
on the fan.
- Do not crush, bend, puncture or shred the fan. Avoid dropping or placing heavy objects on the
fan.
- Do not plug or store the fan in a sealed container where it may short-circuit with other metallic
or conductive objects.
- Do not use the fan if it has been wet or otherwise damaged, to avoid electric shock, explosion
or injury. Contact the dealer or an authorized agent.
- Children's use of the fan should be monitored; this product is not a toy! Read the operating
instructions (including charging instructions and information on minimum and maximum
operating temperatures) supplied with the fan.
Charging mode
Charge Fully before the first use for at least 24 hours! This maximizes battery performance and
extends the life of lithium batteries. Charge your fan once every three months when not in use
or rarely used.
Use only the supplied USB-C to USB-A charge cable and connect it with the TYPE-C charge
input connection. You can use any available high powered USB power source / car chargers
/ (PD) adapter with at least 5V DC 2A (2000mA) minimum power or higher. The full charging
time depends on the selected USB source and it's output. The RED led light is indicating that
the device is being charged and flashes when discharged. When the led is WHITE it means the
battery is fully charged.
Remove charging cable from the device when ready and disconnect the source/adapter from
the mains power socket. Do not bend or twist the USB power cable and when not in use
disconnect it.
Note
If a short circuit occurs, the fan will automatically switch off and the safety protection mode
will kick in.
Battery status
Battery level can be checked by the led status: Press the button once to check the battery status
of the Fan via the LED indicator and the fan is activated.
Operation
1. Charge the fan via the factory provided USB cable as that will make sure this will get the
fastest possible charging speed for your device.
2. Connect your fan to the USB-C port via the charging cable.
3. Then connect the USB-A side to the output port of your USB power source.
Tip: you can use the fan at the same time while charging.
Power button
Press the button 1x to power ON the fan. At the same time the swinging/moving of the fan will
start as well. Press the button again to stop the swinging/moving function. Press again to switch
the fan completely OFF.
Tip: you can use the swing way as up/down as standard or left/right by rotating the complete fan
itself at 45 degrees clockwise use position.
Power slider
When the fan is in use, the power slider switch can be moved from left to right and vice versa,
and the air capacity will be more or less in fan speed.
Security and important safety instructions
When using electrical products, certain precautions must be followed, including the following:
- Choose a stable, solid and supportive surface and make sure the fan is set correctly.
- This device is intended for inside use!
- This is not a TOY, keep away from small children below 12 years.
- Do not use with appliances that could cause any fire in unattended use (like irons etc.).
- Any other use as the intended way for this device is not validated for any warranty or liability.
- Do not use the device excessively and do not store them under heavy pressure. The device is
not resistant to extreme heat.
- Do not open or disassemble the device yourself, this will void the warranty at all times.
- Do not disassemble, repair or modify the product by yourself as this may result into an electric
shock.
- Do not stand, sit on, jump or throw with the device at all times.
- Do not throw this product in the air to avoid damage caused by falling.
- Only use the device for its intended designed use as a fan cooling product.
- Under extreme conditions the battery cells can cause leaking. If that fluid touches the skin then
please clean directly with water and soap. If within the eyes then clean with water for at least
10 minutes and consult a doctor.
FlinQ Coolcube
Advertenties
