Advertenties
Beschikbare talen
Beschikbare talen
1. Mode To select whether photos or videos should be recorded, select "Photo" or
"Video", or use the Up / Down selector function on the menu. Target selection will
be displayed on the upper left screen. Warning! The camera will automatically switch
to "Video" mode as soon as the "Test" key is activated. Pay attention to the infor-
mation displayed on the upper left screen! In the "Photo + Video" mode, the camera
will first take a photo and then begin to record video.
2. Taking a Photo
Select an image size: 1 MP , 3 MP , 5 MP , 8 MP (pre-selected), 12 MP , 16 MP , 20 MP
or 32 MP . The higher the resolution, the more detailed the image will be. However,
the number of high-resolution images that can be stored on the card will be less.
3. Serial recording
Select the number of photos to be taken in sequence when the camera is in photo
mode. In addition to single-shot mode (1 photo), you can set "2, 3 or "10 photos in
a row".
4. Recording a Video
Select
the
screen
resolution:
3840x2160/10fps,
2688x1520/20fps,
1920x1080/30fps, 1280x720/60fps, 848x480, 720x480/30fps, 640x480, 320x240.
Again, the higher the resolution, the sooner the capacity limit of the memory card
will be reached.
5. Time-Lapse: video resolution 5200x3900P , 4680x3456P , 4416x3312P ,
4000x3000P ,
3840x2160/10fps,
3648x2736P ,
3264x2448P ,
3072x2304P ,
2592x1944P , 2048x1536P , 2688x1520/20fps.
6. Video length Use the Up / Down keys to select the length of a video recording
(between 3 seconds - 2 minutes). The operating time is lessened the longer the re-
cording goes on.
7. Sound recording Select this function using the "On" key. You can now record
audio to accompany your video recording.
8, Shooting range
Use the On / Off keys to select the interval at which the camera should take a photo
after it has just taken one. This feature prevents too many images being taken of
the same event. You can select between 5-60 seconds or 1-60 minutes.
9. Side Motion Detector On / Off
10. Motion sensor sensitivity.
The sensitivity of the main movement sensor is set here. For indoor areas and sur-
roundings with few incidents, select "High". Select "Medium" for outdoor areas in
which there is a normal amount of movement. Select "Low" for areas with a high
amount of movement. The temperature can influence the sensitivity. The "High" set-
ting is ideally suited to warm temperatures, while "Low" should be selected for col-
der areas.
13
Advertenties
