GENERAL INFORMATION
General
These are the mounting instructions for the Novy unit shown on the cover. The user manual is delivered separately with
this unit. Carefully read these instructions before installing and commissioning this unit. It is recommended to have one
or more qualified persons carry out the installation.
This manual makes use of a number of symbols. The meaning of these symbols are given below.
Symbol
Safety
Observe the following mounting and safety tips for mounting:
•
The installation and electrical connection of the unit shall be carried out by an authorised expert.
•
The manufacturer does not accept any responsibility for any damage resulting from faulty building in or connection.
•
Carefully take the unit from the packaging and check it for damage before mounting.
•
Do not mount the unit in case of any damage.
•
Check if all mounting materials have been supplied using the drawings at page 2.
•
The unit is intended for household use only (preparation of food) excluding any other domestic, commercial or industrial
use.
•
Safety can only be guaranteed if the unit is connected to an earth wire in accordance with the required regulations.
•
Do not use an extension cord for connecting to the electricity grid.
•
Replace defective or damaged parts only with original Novy parts.
•
Replace a damaged power cable with an original Novy power cable.
Important before mounting
Page 2 of these mounting instructions show the mounting drawings. Observe the following mounting tips before starting
the mounting activities:
•
For easier mounting of the ceiling unit, it is recommended to do this with at least 2 persons.
•
Make sure that the wall has sufficient load bearing capacity.
•
Position the wall socket in such a way that it is behind the ceiling unit.
•
Position the wall socket such that it is above the motor housing.
INSTALLATION
Follow the mounting drawings on page 2.
Check the mounting materials against drawing 1.
1
Determine the mounting height 'h' above the hob:
2
•
Recommended mounting height with induction, electric or ceramic hob (Hmin-Hmax) (mm): 500 - 750
•
Mounting height with a gas hob (Hmin-Hmax) (mm): 650-750
•
The height at which the 2 mounting hooks are mounted is determined by: chosen height "h" + 480 mm. Draw a
level horizontal line at this height.
•
Drill the holes in the wall using an 8 mm drill. The distance between the 2 holes is 510 mm (ensure that hood is
positioned centrally above the cooker plate).
Position the 2 mounting hooks in the wall. The suspension can be levelled by turning the adjustment screws (below).
3
This can be done beforehand, or after the extraction hood has been removed from the wall.
Hang the extraction hood over the mounting brackets.
4
Grasp the underneath of the glass plate (A) at the left and right and pull it firmly forwards. Open the glass plate so that
5
the grease filter is visible. You can remove the metal grease filter (B) from the hood.
There are 2 holes on the inside of the hood. Mark these holes on the wall. Depending on the wall, you can position the
6
screws directly in the wall or remove the hood from the wall first, drill the holes, and use the plugs and screws. After
this, replace the hood in the brackets and fasten the hood to wall with the 2 screws.
7
The wall socket is directly above the hood.
Put the plug into the wall socket.
Meaning
Indication
Warning
Action
Explanation of an indication on the hood
This symbol indicates an important tip or a
dangerous situation.
EN 9