Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Setting the time
•
Press the big-flame button and the small-flame button simultaneously, and the display will show short
flashes to indicate that you are in the set mode.
•
When in the set mode, press the big-flame button to set the hours, and press the small-flame button
to set the minutes.
•
Wait or press the OFF button to return to manual control.
Switching from ºC/24-hour to ºF/12-hour indication
•
Press the OFF button and the small flame button simultaneously (2 sec) to switch from ºF (and the 12-
hour indication) to the ºC (and the 24-hour indication), and vice versa.
Possible settings
•
By pressing the SET button you can switch quickly between MAN day temperature lamp ventilator
night temperature timer MAN.
•
MAN: this setting allows you to turn the flames manually higher or lower with the big-flame button or the
small-flame button .
•
Day temperature (): this mode allows you to set the desired daytime temperature; the remote control set
will function as a thermostat.
•
Night temperature (): this mode allows you to set the desired night temperature.
•
TIMER: this mode allows you to preset 2 switch-on and 2 switch-off times per 24 hours. If the night setting is
on - - -, the stove will burn on the pilot flame.
Setting the temperature
Select the day temperature or night temperature by briefly pressing SET button .
•
•
Now press SET button longer until the display starts flashing.
•
Preset the temperature with buttons or (5 ºC is the minimum day temperature).
•
Wait or press OFF button to switch back to the thermostat-controlled system.
•
In order to save the batteries you are advised to reset the night-temperature until the display shows the '- - -'
signal.
Setting the timer function
•
Select the timer function by briefly pressing SET button a few times.
Now press the SET button longer until P1 () starts flashing.
•
•
Set the hours with button and the minutes with button .
Briefly press SET button for the next timing.
•
•
Once all 4 timings have been set, press OFF button to end the presetting.
Operation (remote control)
Igniting the fire
•
Open the gas turncock that is fixed in the gas pipe leading to the stove.
•
Press "O I" switch on the gas control block in the "I" position.
•
Turn control button on the gas control block to the ON position.
•
Simultaneously press buttons and on the handset. A short acoustic
signal indicates the start, and is followed by short acoustic signals (0.2
sec/signal, 1Hz.) until the pilot flame and the chief burner are ignited.
After the main burner has lit, the flame height will automatically go to
the maximum position.
Possible error messages
•
Long signals (0.8 sec. signal with 0.2 sec. interval) during lighting : batteries of the receiver are almost
empty. (After hearing this signal, you can switch on the appliance for about another 10 times.)
•
5 seconds continuous signal : error message. One of the cables may not be connected, or the "O I" switch
is not in the "I" position.
•
5 short signals (0.2 sec. signal with 0.2 sec. interval) : ignition of the pilot flame and the main burner has
All manuals and user guides at all-guides.com
19
Advertenties
Hoofdstukken
Inhoudsopgave
