Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5. Power jack 6. ON/OFF switch 7. Sound sensitivity knob
8. Key lock 9. DMX or linking jack 10. Dipswitch function setting
Function and Setting
Dip Switch
#1
Sound‐to‐light
OFF
Auto Beam
ON
DMX/Slave mode
ON
As the above chart, DIP switch setting reference as follows:
Stand alone
(1). Sound active: ALL OFF
(2). Auto beam run: #1 ON
Master and Slave mode
(1). DMX and DMX Slave & Master: #1 and #10 ON
(2). All slave units put #2 ON, when master unit puts #1 ON, then all the units run under auto mode; when
master unit puts ALL OFF, then all the units run under sound active mode.
Universal DMX Operation (DMX mode)
This mode allows you to use universal DMX‐512 console to operate.
1. Install the units in a suitable position.
2. Use standard XLR cable to connect your units together via the XLR connector on the rear of the units. For longer cable
we suggest a terminator at the last fixture.
3. Assign a DMX address to each the unit using dipswitches.
4. Turn on all units. Use DMX console to control your units.
#2
#3
#4
#5
OFF
OFF
OFF
#6
#7
#8
#9
#10
ON
Advertenties
Inhoudsopgave
