Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Description
1. This series of hose reel are professional spring-driven models.
2. This series of hose reel is equipped with slow retract function.
3. This series of hose reel can be pulled and stopped at any point during usage.
Tips:
1. Read the following precautions and instructions before you begin assembly or using.
2. Failure to comply with these instructions could result in personal injury or property damage.
3. Keep these instructions in a convenient location for future reference.
1. Make sure incoming line pressure does not exceed rated operating pressure for your model hose reel.
2. Use proper eye protection when assembling and using the hose reel.
3. Keep children away from the work area.
4. For long-time non-use, please empty the hose.
5. If long-term preservation of the hose reel, please check whether the hose is aging and
whether the connecting valve is leaking.
WARNING:
Exposure of skin directly to pressurized air, or fluid could result in severe bodily injury.
INSTALLATION INSTRUCTIONS
Prepare tools for installation
For overhead ceiling and wall mounting the installation height should not exceed 3m (10 feet) above the floor.
If the reel you have purchased does not have hose included, you will need to purchase and attach. Refer to
specifications to determine appropriate hose and size.
1. The reel base has four 7/16"(or 11mm) drilled holes for mounting on a suitable flat surface. Figure 1.1
to 1.2 are templates showing the correct location of the 4 mounting holes in the base.
2. The reel is supplied with a hose guide roller bracket. The bracket position may require repositioning depen-
ding on the selected reel mounting position. Figure 2.1 shows "Typical Mounting Positions". If bracket
position needs to be changed, do the following:
(1) Pull out some hose and let reel latch.
(2) Remove side cover and guide arm.
(3) Rotate guide roller bracket to correct position, replace bolts and tighten.
3. Using the four holes in the base, mount the reel in the desired location. Be sure to use appropriate hardware
and tighten securely.
4. Apply Teflon tape or pipe sealant to supply line threads, attach to reel inlet and tighten. The other end of
incoming line can now be connected to desired supply source.
5. If hose has been supplied with reel: Apply Teflon tape or pipe sealant to outlet fitting on reel hose, then
attach to desired tool, or nozzle. Check connection for leakage, also check hose reel for correct operation.
(Details see Operation section.)
6. If hose stopper adjustment is required, pull hose from reel and allow to latch at desired length.
Loosen stopper bolts and slide stopper to a position close to the hose guide. Tighten stopper bolts, and
unlatch the reel.
RODAC.COM INFO: NL: INFO@SAM-RODAC.COM +31 (0)46 458 2299 - BE/LUX: BELUX@SAM-RODAC.COM +32 (0)2 331 34 34 - D: + 49 (0) 3222 1681310
WWW.RODAC.COM
SAFETY PRECAUTIONS
2021
Advertenties
Inhoudsopgave
