Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
26 leonard
Problem
There is too much frost.
Replacing the lamp
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
"Installation".
TECHNICAL DATA
Dimension of the recess
Rising Time
Voltage
Frequency
The technical information are situated in the
rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Possible cause
Food is not wrapped correctly.
The door is not closed correctly.
The temperature regulator is not
set correctly.
1. Disconnect the mains plug from the
2. Remove the screw from the lamp cov-
3. Remove the lamp cover (refer to the il-
4. Replace the used lamp with a new
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the mains plug to the mains
8. Open the door. Make sure that the
Height
Width
Depth
Wrap the food correctly.
Refer to "Closing the door".
Set a higher temperature.
mains socket.
er.
lustration).
lamp of the same power and specifical-
ly designed for household appliances.
(the maximum power is shown on the
lamp cover).
socket.
lamp comes on.
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
1780 mm
560 mm
550 mm
24 h
230-240 V
50 Hz
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the
climate class indicated on the rating plate of
the appliance:
Solution
Advertenties
Hoofdstukken
Inhoudsopgave
