Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Memory function
The memory function can save one switching time for a
ively, and repeat every 24 hours.
Whether or not this function is available depends on the devices used and is
described in the relevant instructions for the receiver.
Intermediate position I + II
The intermediate positions I + II are freely selectable positions for the shading
solution between the two limit positions. Each travel button can be assigned
one intermediate position. Both limit positions must be set before an interme-
diate position is set.
Whether or not this function is available depends on the devices used and is
described in the relevant instructions for the receiver.
Installation key
All of the devices operating within an installation must have the same installa-
tion key in order to communicate with one another. This key is created on ini-
tial commissioning, and is then transmitted to the additional added devices.
The installation key is only known to the programmed devices, and cannot be
read off. The commissioning procedure is described in the relevant instruc-
tions for the receiver.
Operating modes
Normal mode
Receiver selection
Setting mode
Press and hold the programming button for 3 seconds to access receiver se-
lection.
You can now press the programming button once to switch back and forth
between receiver selection and setting mode.
To access normal mode, press and hold the programming button for 3
seconds.
Control of selected receiver/channel
Selection of the required receiver and chan-
nel assignment
Commissioning and administration of selec-
ted receivers
and
run respect-
23 - en
Advertenties
Hoofdstukken
Inhoudsopgave
