Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
˜ Fitting
1. Take the car cover out of the storage bag.
2. Make sure which part goes on the front of vehicle!
You can identify the front by the sewn-on label with the word
"FRONT" on it.
3. Open the click fasteners on the straps.
4. Fold in wing mirrors if possible.
5. Attach the car cover to the front of your vehicle by using the sew-in
rubber strip.
6. Pull the car cover over the vehicle (Fig. 1)
Attention: if your vehicle has a rod aerial at the rear, please
unscrew it. Please push in telescopic aerials.
Please carefully push down any aerials in the front roof area and lay
them parallel to the roof. Make sure not to damage the aerial or the
paintwork!.
7. Now attach the car cover to the rear of your vehicle by using the
sewn-in rubber strip.
8. Then fasten the straps to the front and back of your car. To do this,
guide the straps from front to back underneath your car and fasten
them with the click fasteners. (Fig. 2.1 (front) and 2.2 (back)). Finally,
tighten the straps (Fig. 3.1 (front) and 3.2 (back)).
GB/IE/NI
7
Advertenties
Inhoudsopgave
