Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
5 | cLEANING & mAINtENANcE
Before cleaning the larder always unplug the appliance.
Clean the interior of the appliance. Use warm water and
a neutral detergent to prevent any bad smells occurring.
after cleaning, rinse the interior with clean water and rub
dry. leave the appliance to dry for 1 to 2 hours. Simply
remove the shelves, drawer and door compartments to
clean them by hand. do not clean the interior accessories
in the dishwasher.
Clean the outside of the larder and the gasket with a soft
moist cloth.
We recommend that you dus the back of the appliance
with a cloth or vacuum cleaner once a year in order to
maintain a good output and low energy consumption.
Defrosting of the larder compartment is completely
automatic. droplets of water on the rear wall of the larder
compartment indicate that the periodic automatic defrost
cycle is in progress. The defrost water is automatically
routed to a drain outlet and into a container from which it
evaporates.
REpLAcING tHE buLb
When replacing the bulb, proceed as follows:
• Unplug the appliance from the mains.
• remove the lamp cover by unscrewing the screw and
pull the lamp cover towards you.
• First check if the bulb is fully screwed in.
• If the bulb is defective, replace it with a bulb of the same
type: maximum 10 Watt, socket e14. This kind is widely
available.
• replace the cover and the screw.
• Plug the appliance back into the mains.
6 | tRoubLESHootING
Problem
Cause
appliance is not
aplliance is not
functioning;
plugged in
light does not
work
Temperature
Thermostat has
inside the
been set
larder is too high
incorrectly
or too low
air
circulation
vents are
blocked
Water is running
drain outlet is
out of the
blocked
larder
Note: gurgling and hissing noises due to expansion in the
refrigerant circuit are normal.
It is possible to change the door opening from either the
left or the right side. The appliance is delivered with the
door opening from the left side. To change the opening
direction, please follow these instructions.
Note: Before reversing the door swing, unplug the
appliance from the mains.
• remove the screws at the back, holding the top panel
Solution
Plug the
• lift the top panel at the backside and remove it.
appliance in the
socket
Set the
thermostat
correctly
Clean the
ventilation
openings
Clear the drain
outlet with a
skewer
13
Problem
Cause
appliance is
Has the
excessively noisy
appliance been
installed
correctly?
are the pipes
at the back
touching or
vibrating?
The inside light
lamp is
is not working
defective
7 | REvERSING tHE DooR opENING
to the appliance.
Solution
Check the
installation
Check it and
move the
appliance
forwards
replace the bulb
following the
instructions
Advertenties
Inhoudsopgave
