Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
INSTALLATION
Follow the installation steps below:
1.
Install the grounding adapter to the laser with the screw and tighten.
2.
Insert the grounding adapter into the ground.
3.
Adjust the angle and then fix the screw.
4.
Connect de power.
REMOTE CONTROLLER
1.
ON
2.
Lasers full on. You can change rotation speed with + or –
button.
3.
Choose your laser colour, Red or Green.
4.
Timer, shut down automatically after 0.5hours
5.
Timer, shut down automatically after 3hours
6.
Auto program
7.
Laser Red and Green on.
8.
Stop timer
9.
Timer, shut down automatically after 5hours
10. OFF
11. Strobe
12. Speed +
13. Speed -
14. Timer, shut down automatically after 8hours
Note: Remote controller distance range is approx. 10 meter without
any barrier.
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the foil
from the battery support on the rear side of the remote control. Otherwise operation of the remote control is not
possible.
If the range of the remote control decreases, replace the battery. For this purpose, on
the rear side of the remote control press the small bar with the groove to the right (1)
and at the same time remove the battery support (2). For operation, one 3V button cell
type CR 2025 is required. When inserting, pay attention that the positive pole of the
button cell shows upwards in the support.
4
CAUTION:
Please consider the respective national norms during the
installation!
CAUTION:
When installing the device, make sure there is no highly in
inflammable material (decoration articles, etc.) in between a
distance of min 0.5 meter.
Advertenties
Inhoudsopgave
