Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Do not use the product if you detect any
damage.
In the event of damage, repairs or other
problems with the product, please consult an
electrician.
Never open any of the components of the
electrical equipment or insert any objects into
the same components. This will pose a risk of
fatal injury from electric shock.
For installation, please contact qualified
electrician if you have any doubt.
Do not use this product for dimmers or
electronic switches. It is not suitable for these
purposes.
Before installation, check whether the
included mounting material is suitable for the
wall or ceiling on which you are aiming to
mount the product.
Do not use the light if it is visibly damaged in
any way.
If the glass cover is broken, the entire product
must be replaced.
The LED bulb is not dimmable.
The luminaires is not compatible with any
dimmer
The LED bulb can only be replaced by same
model or same type of LED bulb.
Only use 230 V∼ LED bulbs with a E27 base
and a maximum output of 20 W.
˜ Before use
Note: Remove all packaging materials from the
product.
Important: The electrical connection must
be established by a qualified electrician or a
person instructed in electrical installation. They
must be aware of the properties of the light and
regulations on electrical connections.
Before installation, familiarise yourself with all
instructions and illustrations in this booklet and
with the light itself.
Before installation, make sure that there is
no voltage present in the cable to which you
plan to connect the light. To do this, remove
the fuse or turn off the circuit breaker in the
fuse box (0 position).
Use a voltage tester to check that no voltage
is present.
˜ Installation
Note: You will need an electric drill for the
installation.
CAUTION! RISK OF INJURY! Please refer to
the operating instructions of your electric drill.
Mounting the light on a wall/ ceiling
Remove the fuse or turn off the circuit breaker
in the fuse box (0 position) before you start to
install the product.
Turn the glass cover 1 anti-clockwise against
the base 3 . (See Fig B)
Unscrew and remove luminaire connector
cover 6 and cable anchorage 8 .
(See Fig C)
Hold the base 3 in the desired installation
position. Note the connection cable 7 will
be fed through the base. Use a pencil to mark
where to drill holes for the desired installation
position. (See Fig. D)
Using a 6 mm masonry drill, drill an approx.
40 mm deep hole into the marked positions.
(See Fig. E)
Insert the dowel 11 into each drill hole. If
necessary, use a hammer to help you insert
the plugs.
Guide the connection cable 7 through the
sleeve tube 14 and into the seal 12 through
the opening provided in the base 3
(See Fig. F).
Fix the base 3 to the ceiling/ wall using the
mounting screws 11 .
Use a screwdriver to fasten the connection
cable 7 to luminaire connector 13
(See Fig. H).
Note: Make sure that you insert and fasten
the individual wires from the building's
electrical wiring to the correct marking in the
luminaire connector 13 .
Live wire: black or brown, L symbol. Neutral
wire: blue, N symbol. Earth wire: green-
yellow.
Note: The LED ceiling light has a double-
insulated design. The earth wire does not
GB/IE/NI
9
Advertenties
Hoofdstukken
Inhoudsopgave
