Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
OPERATION
1.
Connect loudspeaker system (MINIMUM load 4 ohms) with sufficient handling capacity to the output terminals of the
amplifier.
2.
Connect output from television, dvd player, computer, mixer or any other suitable signal source to the appropriate input
sockets of the power amplifier. On the front panel you can connect your CD player with a 3.5mm stereo jack connection
lead. On the front panel of the amplifier is a MP3 control panel having USB/SDmmc inputs. The amplifier is
supplied with a remote control with which the MP3 panel can be controlled too, as well as the built-in
equalizer.
3.
Connect the power cord to the mains.
Select the correct source with the selector on the front. (PC – MP3 – TV – CD)
4.
5.
Turn gain controls to minimum , switch on the amplifier.
6.
Adjust the volume controls to required level. NOTE. If the audio input signal is too high, distortion will result and the
CLIP indicator will light. If the clip LED is lit permanently or flashes, the level should be reduced.
SPL–MP3 SERIES
6
3
4
7
5
4
3
2
1
- 4 -
1
.
Power switch
. 2
Power on/off indicator
3 .
Channel A & B volume
4 .
Signal LED Channel A & B
. 5
Clip indicator
. 6
Input selector
7
.
MP3 Input
Front Panel
control
Rear Panel
1.
Inputs Channel A & B
( RCA phono sockets)
2.
Channel A & B output
3.
Mains input power & fuse
holder
4.
Fan only on SP700EQ &
SPL100EQ
Advertenties
Inhoudsopgave
