Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Rear Panel
OPERATION
1.
Connect loudspeaker system (MINIMUM load 4 ohms) with sufficient handling capacity to the output terminals of the
amplifier.
2.
Connect output from television, dvd player, computer, mixer or any other suitable signal source to the appropriate input
sockets of the power amplifier. On the front panel you can connect your MP3 player with a 3.5mm stereo jack
connection lead.
3.
Connect the power cord to the mains.
Select the correct source with the selector on the front. (PC – MP3 – TV – CD)
4.
5.
Turn gain controls to minimum , switch on the amplifier.
6.
Adjust the volume controls to required level. NOTE. If the audio input signal is too high, distortion will result and the
CLIP indicator will light. If the clip LED is lit permanently or flashes, the level should be reduced.
7.
Use the equalisers to make adjustments to the sound. They can compensate for sound quality differences in the source
material, or differences in room acoustics. Each EQ has his own boost or cut for the low, mid & high frequencies
.
For reliable and trouble free operation, please observe the following points:
•
Ensure all input / output connections are correct and secure.
•
The handling capacity of the loudspeakers is adequate for the output of the amplifier.
•
Always site the amplifier in a well ventilated location
•
Protect unit from severe shocks
•
Do not plug in or unplug the speakers during the operation of the amplifier. This would seriously damage the
amplifier.
SPECIFICATIONS
Max Output Power @
4 Ohm
Max Output Power @
8 Ohm
Load Impedance
minimum
Input
Connectors
Output
Input Sensitivity
Input Impedance
Frequency Response
THD +N
Signal to Noise Ratio.
Cross-talk
Indicators
Mains Power
Fuses
Dimension(W X D X H)
Weight
SPL–EQ SERIES
SPL
SPL
500EQ
700EQ
2x 250W
2x 350W
2x 200W
2x 250W
6x RCA (phono) socket & 3.5mm Stereo Jack
220~240 Vac(Euro) / 50 Hz
T1A
4,2kg
3,5kg
- 4 -
SPL
1000EQ
2x 500W
2x 350W
4 Ohm
Speaker terminal board
775 mV
10 K min.
20 Hz - 20 KHz ±3 dB
< 0.5 %
>95 dB
> 82dB at 1KHz
Clip / Signal / Power
T2A
T4A
482 X 290 X 88mm
4,8kg
1.
Inputs Channel A & B (
RCA phono sockets)
2.
Channel A & B output
3.
Mains input power & fuse
holder
4.
Fan only models from
SP700EQ
SPL
SPL
1500EQ
2000EQ
2x 750W
2x 1000W
2x 500W
2x 750W
T4A
5,4kg
6kg
Advertenties
Inhoudsopgave
