9
Wine
Note: please store different foods according to the compartments or target storage temperature of your purchased products.
- If the refrigerating appliance is left empty for long periods, switch off, defrost, clean, dry, and leave the door open to prevent
mould developing within the appliance.
WARNING -Food needs to be packed in bags before putting into the refrigerator, and liquids need to be packed in bottles or
capped containers to avoid the problem that the product design structure is not easy to clean.
6
cleaning & maintenance
Before cleaning the appliance set the thermostat to OFF and always unplug the appliance.
Remove the food. Clean the interior of the appliance. Simply remove the shelves, drawers and door compartments to clean them
by hand. Do not clean the interior accessories in the dishwasher. Use warm water and a neutral detergent, such as baking soda, to
prevent any bad smells occurring. Use two tablespoons and a quart liter of warm water. After cleaning, rinse the interior with clean
water and leave the door open to let it air dry for 1 to 2 hours before the power is turned on. Be careful not to affect the electrical
insulation properties when rinsing with water.
For areas that are difficult to clean in the refrigerator, such as narrow gaps or corners, it is recommended to wipe them
regularly with a soft rag, soft brush, etc. When necessary use some auxiliary tools, such as thin sticks (tooth picks), to ensure no
contamination can accumulate in these areas.
Clean the outside of the refrigerator and the door gasket with mild soap and water. Use a soft moist cloth.
We recommend that you dust the back of the appliance and on the floor with a cloth or vacuum cleaner once a year in order to
maintain a good output and low energy consumption.
Do not use hard brushes, cleaning steel wire balls, wire brushes, abrasives, such as toothpastes, organic solvents (such as alcohol,
acetone, oils, etc.), boiling water, acid or alkaline items to clean the refrigerator considering that this may damage the fridge
surface and interior. Boiling water and benzene may deform or damage plastic parts.
REPLACING THE LED LIGHTING
This appliance is equipped with a LED light bulb. It can be used for a long time. In case, the LED bulb is blown, it must be replaced
by a qualified person to avoid any hazard. Contact the Inventum service department.
7
troubleshooting
Problem
Appliance is not functioning;
light does not work
Temperature inside the
larder is too high or too low
Appliance is excessively noisy
Note: gurgling and hissing noises due to expansion in the refrigerant circuit are normal.
+5 ≤+20
Red wine, white wine, sparkling wine, etc.
Cause
Appliance is not plugged in
Thermostat has been set
incorrectly
Air circulation vents are blocked
Has the appliance been
installed correctly?
Are the pipes at the back
touching or vibrating?
Solution
Plug the appliance in the socket
Set the thermostat correctly
Clean the ventilation openings
Check the installation
Check it and move the appliance forwards
23
English
•