Bosch DWK 5DK 0 Series Gebruikershandleiding En Installatie-Instructies pagina 30
Verberg thumbnails
Zie ook voor DWK 5DK 0 Series:
- Gebruikershandleiding en installatie-instructies (60 pagina's)
Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
en Installation instructions
3.
Align the appliance horizontally using screws and
screw it in tightly.
4.
Attach and screw in the two additional safety
screws.
5.
Insert the grease filter.
To avoid causing damage, do not bend the grease
filters.
6.
Close the glass flap.
Slightly raise the glass flap and pull it forwards in
‒
order to loosen the securing position of the
hinges.
Carefully guide the glass flap downwards until it
‒
clicks into place.
Piping
Circulating-air mode
If you are operating the appliance in circulating-air
mode, please observe the information about the circu-
lating air special accessory.
Note: If you are using an aluminium pipe, smooth the
connection area beforehand.
We recommend the piping with an exhaust air pipe dia-
meter of 150 mm.
Establishing the exhaust air connection
(exhaust pipe, 150 mm diameter)
1.
Secure the exhaust pipe to the air pipe connector.
2.
Establish the connection to the exhaust air opening.
3.
Seal the joints.
Establishing the exhaust air connection
(exhaust pipe, 120 mm diameter)
1.
Secure the reducing connector to the air-pipe con-
nector.
30
2.
Secure the exhaust pipe to the air pipe connector.
3.
Establish the connection to the exhaust air opening.
4.
Seal the joints.
Connecting to the power supply
1.
Insert the mains plug into the protective contact
socket.
2.
If a fixed connection is required, follow the instruc-
tions in the section
→ "Instructions for the electrical connection",
Page 27.
Fitting the flue duct
WARNING ‒ Risk of injury!
Components inside the appliance may have sharp
edges.
Wear protective gloves.
▶
Note: In circulating-air mode, the flue duct section must
be installed before the circulating-air guide is installed.
You can find information about installing the circulating-
air guide in the installation instructions for the access-
ory.
▶
Screw the upper flue duct section to the ends of
both angle brackets.
Removing the appliance
1.
Remove the flue duct.
2.
Disconnect the appliance from the power supply.
3.
Loosen the exhaust pipe.
4.
Remove the filter.
To avoid causing damage, do not bend the grease
filters.
5.
Loosen the screws for the appliance bracket slightly
but do not undo them fully.
6.
Remove the appliance.
7.
Loosen the angle bracket for the flue duct.
Advertenties
Hoofdstukken
Inhoudsopgave
