Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Problem
Water flows on the
ground.
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.
REPLACING THE LAMP
CLOSING THE DOOR
1.
Clean the door gaskets.
2.
If necessary, adjust the door. Refer
to "Installation".
Possible cause
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regulator
is not set correctly.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circula-
tion in the appliance.
1.
2.
3.
4.
5.
6.
7.
8.
3.
Solution
Attach the melting water
outlet to the evaporative
tray.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the
door".
Let the product tempera-
ture decrease to room tem-
perature before storage.
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Disconnect the mains plug from the
mains socket.
Remove the screw from the lamp
cover.
Remove the lamp cover (refer to
the illustration).
Replace the used lamp with a new
lamp of the same power and spe-
cifically designed for household ap-
pliances. (the maximum power is
shown on the lamp cover).
Install the lamp cover.
Tighten the screw to the lamp cov-
er.
Connect the mains plug to the
mains socket.
Open the door. Make sure that the
lamp comes on.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH
35
Advertenties
Hoofdstukken
Inhoudsopgave
