Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
6.2 Cable connector
1
2
3
1
Lock nut
3
Terminal case
5
Cable clamp
7
Sealing ring
7 Installation
Important:
– The product must be installed in the correct orientation (e.g., light panel facing down
and sensor facing up).
– The luminaire attachment should be capable of supporting the weight of the product
and any other external fixtures.
– Do not overtighten screws.
7.1 Luminaire
Notes:
– For vertical post mounting, completely remove the spigot screws, rotate the spigot
180°, and then reattach it.
– If only adjusting the lighting angle do not completely remove the M8 screws.
7.2 Photocell sensor
The photocontrol unit automatically switches lights ON at dusk and OFF at dawn. It is
equipped with a delay to reduce false triggers caused buy stray light sources e.g., car head-
lights.
Important:
The aperture on the photocontrol unit should point north to prevent damage and/or false
triggering caused by direct sunlight.
1. Loosen both fixture screws using a cross-head screwdriver.
2. Use a flathead screwdriver to rotate the fixture so the NORTH arrow points north.
3. Tighten both screws.
4. Attach the sensor to the fixture (twist to lock) so the NORTH arrow on the sensor aligns
with the NORTH arrow on the fixture.
7.3 Wiring
10-13mm
22-26mm
8 Cleaning
Important:
– Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions.
They damage the housing and can cause the product to malfunction.
– Do not immerse the product in water.
1. Switch the product off.
2. Let the product cool down to ambient temperature.
3. Clean the product with a fibre-free cloth. Moisten if required.
5
4
5
7
8
2
Cable clamp
4
Terminal block
6
Lock nut
8
Sealing ring
10-13mm
22-26mm
9 Disposal
6
This symbol must appear on any electrical and electronic equipment placed on
the EU market. This symbol indicates that this device should not be disposed of
as unsorted municipal waste at the end of its service life.
Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose
of it separately from unsorted municipal waste. Spent batteries and accumulators,
which are not enclosed by the WEEE, as well as lamps that can be removed from
the WEEE in a non-destructive manner, must be removed by end users from the
WEEE in a non-destructive manner before it is handed over to a collection point.
Distributors of electrical and electronic equipment are legally obliged to provide free take-
back of waste. Conrad provides the following return options free of charge (more details on
our website):
■
in our Conrad offices
■
at the Conrad collection points
■
at the collection points of public waste management authorities or the collection points
set up by manufacturers or distributors within the meaning of the ElektroG
End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of WEEE may apply
in countries outside of Germany.
10 Technical data
10.1 General
Operating voltage ........................... 120 - 277 V/AC, 50/60 Hz
Colour temperature......................... 6500 K (cool white)
Colour rendering (Ra)..................... 70
LED life........................................... approx. 50000 hrs
Dimmable ....................................... no
Ingress protection........................... IP65
Cable type ...................................... H05RN-F (3 x 1.0 mm
Mounting options ............................ Side entry
Angle adjust.................................... ±15°
Surge protection ............................. max. 10 kA
Material........................................... Aluminium die-cast, heatsink housing
Mounting height.............................. 6 - 12 m
Operating/storage conditions.......... -20 to +40 °C
10.2 Item No.: 2986429 / Model No.: BT-HKE30W
Number of LED............................... 24
Energy consumption....................... 30 kWh/1000 h
Brightness....................................... 5100 lm
Weight ............................................ 1.05 kg
10.3 Item No.: 2986430 / Model No.: BT-HKE60W
Number of LED............................... 32
Energy consumption....................... 60 kWh/1000 h
Brightness....................................... 10200 lm
Weight ............................................ 1.59 kg
10.4 Item No.: 2986431 / Model No.: BT-HKE100W
Number of LED............................... 72
Energy consumption....................... 100 kWh/1000 h
Brightness....................................... 18000 lm
Weight ............................................ 2.33 kg
10.5 Item No.: 2986432 / Model No.: BT-HKE150W
Number of LED............................... 108
Energy consumption....................... 150 kWh/1000 h
Brightness....................................... 27000 lm
Weight ............................................ 2.88 kg
10.6 Item No.: 2986433 / Model No.: BT-HKE200W
Number of LED............................... 144
Energy consumption....................... 200 kWh/1000 h
Brightness....................................... 36000 lm
Weight ............................................ 3.47 kg
2
)
post top
clamping voltage ≤1.8 kV
Advertenties
Inhoudsopgave
