Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Clean and dry the freezer comparment. Switch the thermostat
on to the right setting. When the freezer compartment reaches
its correct temperature, replace the food items.
7
cleaning & maintenance
Before cleaning the appliance set the thermostat to OFF and
always unplug the appliance.
Clean the interior of the appliance. Use warm water and a
neutral detergent to prevent any bad smells occurring. After
cleaning, rinse the interior with clean water and rub dry. Leave
the appliance to dry for 1 to 2 hours. Simply remove the shelves,
drawer and door compartments to clean them by hand. Do not
clean the interior accessories in the dishwasher.
Clean the outside of the appliance and the gasket with a soft
moist cloth.
REPLACING THE BULB
When replacing the bulb, proceed as follows:
• Unplug the appliance from the mains.
• Remove the lamp cover.
• First check if the bulb is fully screwed in.
• If the bulb is defective, replace it with a bulb of the same
type: maximum 15 Watt, socket E14. This kind is widely
available.
• Replace the cover.
• Plug the appliance back into the mains.
8
troubleshooting
Problem
Cause
Appliance is not
Appliance is not
functioning; light
plugged in
does not work
Temperature
Thermostat has
inside the
been set
refrigerator is too
incorrectly
high or too low
Air
circulation vents
are blocked
Appliance is ex-
Has the
cessively noisy
appliance been
installed
correctly?
Are the pipes at
the back touch-
ing or vibrating?
Note: gurgling and hissing noises due to expansion in the
refrigerant circuit are normal.
Solution
Plug the
appliance in the
socket
Set the
thermostat
correctly
Clean the
ventilation
openings
Check the
installation
Check it and move
the
appliance
forwards
9
reversing the door opening
It is possible to change the door opening from either the left or
the right side. To change the opening direction, please follow
these instructions.
Note: Before reversing the door swing, set the thermostat
on OFF and unplug the appliance from the mains. Empty the
appliance, including the shelves before reversing the door
opening.
• Remove the two screws at the back, holding the top panel
to the appliance.
• Lift the top panel and remove it.
• Remove two bolts from the left top side and remove from the
right top side the hinge with the three bolts (mind the plastic
parts between the hinge and the door).
• Remove the door by carefully lifting it from the bottom hinge.
Put the door in a safe place.
• Remove and fit the plastic nog from the right side to the left
side.
• Tilt the appliance 45°.
• Unscrew the two bolts and remove the bottom hinge. Install
the bottom hinge on the opposite side und replace the bolts
in the provided holes.
• Replace the front leg on the right side with the bolts.
• Place the door against the appliance and make sure it is well
fitted on the bottom hinge.
• Refit the hinge on the left top side (mind the plastic parts)
with the bolts. Make sure the door is alligned with the outside
of the appliance.
• Set the appliance carefully upright.
• Screw the bolts back on the right top side.
• Remove the plastic part from the inside of the top panel and
place it on the opposite side.
• Refit the top panel using the screws.
• Leave the appliance to stand for at least 3 hours before
you insert the plug into the socket.
15
English
•
Advertenties
Inhoudsopgave
