Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
13. CONNECTION AND REGULATION OF KONTAKT 155/R WITH CO
BOTTLE
1. Screw speed fittings onto the keg coupler.
2. Plug 3/8" and 5/16" hoses into the speed fittings on the keg coupler.
3. Connect the 3/8" and 5/16" hose with the speed fittings located on the cooler in accord-
ance with the description found on the label above the speed fittings.
4. Screw the high pressure hose onto the CO
5. Fit the keg couplers onto the beverage keg, but leave the keg coupler in closed position
(top position).
6. Open the valve on the CO
set the desired pressure for both the separate beverage lines. (The set pressure is displayed
on the pressure gauges located on the front of the cooler).
7. Tap the keg using the keg coupler.
WARNING: Check that all joints are sufficiently leak-tight after connection.
If everything is in order, check the thermostat settings (in off position). Connect the cooler to the
power mains. Then use the keg coupler to tap the keg, set the desired pressure (1.0-3.4 bar) and
use the tap lever to pour out some of the beverage. If the cooler contains remnants of sanitation
solution or water, keep the tap lever in open position until only beverage pours out of the tap.
Set the desired beverage temperature on the thermostat.
12
14. HOW TO WORK WITH SPEED FITTINGS
14.1 Speed Fitting Installation
12 b
figure
Grasp the speed fitting and insert the hose all
the way inside the speed fitting body (ca. 20
mm). The end of the hose must be straight so
that it plugs fully into the coupling. If the hose
will not go in, moisten the end of the hose.
bottle using a flare nut.
2
bottle and use the regulating screws on the top of the cooler to
2
PRESSURE
2
Advertenties
Hoofdstukken
Inhoudsopgave
