Advertenties
Beschikbare talen
Beschikbare talen
Description
1. Operation panel
2. Air output grille
3. Base
4. Rotational button (swing)
5. ON/OFF and fan button
6. Power button 1000W / 2000W
7. Timer
8. Thermostatdial +
Location and Connection
Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact your
vendor for inspection or replacement.
Choose a suitable location for the heater which is at least one metre away from any
obstructions, walls or inflammable materials (see also safety instructions).
Make sure a functioning heater is always placed on a solid, flat and horizontal surface.
Check whether the Main switch is set to OFF (O).
Fully extend the power cord and plug into a suitable 220-240V socket. To prevent the
circuit overloading, check that no other appliances are connected to the same group.
Set-up and Operation
Activate the heater by switching the main
switch to I (ON).The display lights up and
shows the ambient temperature. If you take
no further action the light on the display
switches off after 30 seconds.
Push 1 x the ON/OFF and ventilator button.
The ventilator starts and the other functions
can be selected.
Heating. 1 x push = 1000Watt, 2 x push =
2000Watt, 3 x push = back to ventilator only.
Oscillation. Push to start, and then push again
to switch off.
9. Thermostatdial -
10. Display
11. Handle
12. Back
13. Main switch
14. Filter
15. Inlet point remote control
16
Advertenties
