Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
Before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Do daily maintenance. Refer to
on page 10 .
3. Make sure that only approved persons are in the
work area, because there is a risk of serious injury.
4. Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
To use embedded connectivity
Note: Radio transmission by Bluetooth
on the first time of connection to the mains socket, and
stay on after that.
1. Download the iOS or Android app Husqvarna Fleet
Services.
2. Go to https://fleetservices.husqvarna.com for more
information.
To connect the product to a power
source
1. Put the product on a stable and dry surface at the
workplace.
2. Connect the product to a grounded outlet with
continuous voltage, refer to
14 . Make sure that the mains voltage agree with
the rating plate on the product.
3. If the power source is 1-phase, use an adapter.
Refer to
Adapters on page 16 .
To connect the water supply
CAUTION: Use only clean water to prevent
that dirt causes a blockage in the water
system.
CAUTION: Use air pressure to drain the
product from water after use. The water can
freeze and cause damage to the product.
Note: The water coolant does not stop during a power
failure.
8
Operation
Daily maintenance
®
will be enabled
Technical data on page
1. Connect the water hose to the inlet water connector
on the product.
2. Connect the outlet water connector on the product to
the power tool.
3. To adjust the flow of water coolant to the power tool,
refer to the operator's manual for the power tool.
4. Adjust the water pressure at the water source.
1244 - 002 - 18.05.2020
Advertenties
Hoofdstukken
Inhoudsopgave
Probleemoplossen
