Inhoudsopgave
Advertenties
Beschikbare talen
Beschikbare talen
EN
Filling the Water Tank
PLEASE NOTE!
■
Never pour any descaling or cleaning agent or other chemical additives into the water
tank. This may destroy the device and safe working is no longer guaranteed.
■
Never pour more than 700 ml (two measuring cups fi lled up to the MAX marking) of
water into the water tank.
•
Water residues in the water tank are attributable to the fact that this device
has been tested and do not constitute a defect.
•
Only ever use distilled water with the device to prevent calcifi cation and
damage to the device.
1. Make sure that the device is not connected to the mains power and has cooled down
suffi ciently if used previously.
2. Fill the measuring cup up to the MAX marking with water.
3. Open the water tank cover (4) by pressing on the cover on the left.
4. Pour the water from the measuring cup into the water tank (5). Here too you should
note the MAX marking.
For the best results, we recommend pouring no more than 350 ml into the water
tank for each steaming process.
5. Flip the water tank cover back down again.
Assembly
1. Plug the telescopic rod (2) into the recess on the top of the motor unit (6).
2. Place the hanger (1) onto the telescopic rod. When you do this, make sure that the
slight bend in the hanger points forwards. The hanger must audibly engage on the
telescopic rod.
The drip guard (10) must be located directly above the fan (3). It prevents any water
that may drip down from being able to get into the fan.
3. Attach the nylon balloon:
– Pull it over the hanger. When you do this, make sure that the side with the hole line
points forwards.
– Pull the small elastic cord at the top over the collar section (12) on the hanger.
– Pull the large elastic cord at the bottom over the mounting fl ange (9).
The device is disassembled in the reverse order.
18
Advertenties
Hoofdstukken
Inhoudsopgave
