Download Inhoudsopgave Inhoud Print deze pagina

Safety Regulations - PROUSER AMBER IV Montagehandleiding En Veiligheidsvoorschriften

Fietsendrager
Inhoudsopgave

Advertenties

Beschikbare talen

Beschikbare talen

Use of strain relief strap
Before mounting the strain relief strap remove dust and dirt from the top of the
trunk of your vehicle. Open the trunk of your vehicle. Run the free end of the
strap between the trunk door and roof edge outwards (1). Leave about 20cm
free between the anchor and the roof edge. Close the trunk of your vehicle
gently. Make sure the strap is flat and straight between the seals. Now slowly
pull the strap out until the anchor is stopped by the roof edge and the trunk of
your vehicle.
Make sure that any existing roof spoiler is not damaged and that the function of
strain relief strap is not affected by the roof spoiler.
Attach the part of the belt with the buckle on the U-tube of the bike carrier (2).
Connect the two parts of the strain relief strap to each other (3) and pull the
strap tight.
1
2
3

SAFETY REGULATIONS

Keep the tow ball clean and free of grease.
Each time after having mounted the carrier on the tow ball, it will "settle" during
the first kilometres that you drive. Therefore, check if the carrier is still firmly
secured after the first few kilometres and if necessary, tighten the locking bolt.
Check the bike carrier before use if there is any damage. Damaged or worn parts
need to be replaced immediately. Only use original replacement parts.
Do not make any modifications on the bike carrier (mechanical or electronic)
This can be very dangerous. Warranty claims will not be accepted and we cannot
guarantee the correct functionality of the bike carrier, if you done modifications.
We are not responsible for damage caused as result of incorrect assembly,
installation or modification.
Check the correct operation of the lighting at regularly.
Always make sure that the bikes are firmly fixed by using the frame holders and
wheel safety belts.
Always use the extra safety belt, for extra protection of your bikes. Run the
safety belt trough the U-frame and the frames of the bikes, and pull this firmly.
44

Advertenties

Inhoudsopgave
loading

Inhoudsopgave