Pagina 1
NEDERLANDS PRODUCT Naam: Lightyourbike ® - Fietsverlichting Set USB Oplaadbaar - Voorlicht en Achterlicht - LED - Waterdicht EAN: 6090452244231 SPECIFICATIES VOORLICHT Merk: Lightyourbike ® Model: BEAM Accu: High performance polymer lithium Gebruiksduur: 5 - 10 uur (afhankelijk van lichtstand)
Pagina 2
FUNCTIES VOORLICHT Om de BEAM in te schakelen dient de knop aan de bovenkant ingedrukt te worden. Als deze knop eenmaal wordt ingedrukt kunnen de onderstaande functies in- of uitgeschakeld worden: 1. Strong: sterk licht 2. Middle: zwak licht 3. Weak: knipperen van het voorlicht...
Pagina 3
Om de BEAM te monteren volg de onderstaande stappen: 1. Schuif de onderkant van de BEAM (1) in de rails op de houder (2). 2. Plaats de houder op het stuur en bevestig de rubberen band (3) aan de daarvoor bestemde plaats op de houder (4).
Pagina 4
GEBRUIK - De BEAM heeft een IP65 beschermingsgraad. Dit betekent dat deze beschermd is tegen waterstralen. De HALO heeft een IP64 beschermingsgraad. Dit betekent dat deze plens- en stofdicht is. - Als de verlichting voor een langere tijd niet gebruikt wordt, zorg er dan voor dat deze volledig zijn opgeladen en herhaal dit elke 3 maanden wanneer deze niet gebruikt wordt.
Pagina 5
ENGLISH PRODUCT Naam: Lightyourbike ® - Bicycle Light USB Rechargeable - Headlight - BEAM - 300 Lumen - LED EAN: 6090441986913 SPECIFICATIONS FRONT LIGHT Brand: Lightyourbike ® Model: BEAM Battery: High performance polymer lithium Operating time: 5 - 10 hours (depending on light mode)
Pagina 6
3. S.O.S.: Flashing S.O.S. light To read how much battery capacity is available, you can consult the power indicator light on the top of the BEAM: 1. Capacity >99% = 3 indicator lights 2. Capacity 60% - 99% = 2 indicator lights and 1 flashing indicator light 3.
Pagina 7
MOUNTING FRONT LIGHT 1. Slide the bottom of the BEAM (1) into the rails on the holder (2). 2. Place the holder on the handlebar and attach the rubber band (3) to the intended place on the holder (4). 3. Then attach the rubber band (5) to the holder (6) To remove the BEAM follow the steps below: 1.